HSS 8 SG
Description
Like all Hense rotary vane motors, rotary vane motors in the HSS series are designed according to the rotary vane principle. The drive shaft has axial and radial plain bearings in coated bushes. The coating used is tribologically optimized and ensures low wear. Sufficient lubrication of the bearing points is ensured by the supplied hydraulic oil. To reduce the internal friction of the motor, the hydraulic separation of the working chambers in this series is partly achieved by means of pressure and viscosity-dependent throttle sections. HSS motors are ideal for generating oscillating swivel movements in the frequency range with small angular amplitudes in controlled systems. The HSS series is therefore recommended for use whenever semi-dynamic torsion tests need to be carried out reliably and cost-effectively.
- Electric motors and parts
- Hss Axial
- Dynamic Motors
- Lubrication Motors
Product characteristics
- Specific torque [Nm/bar]
- 8,16
- Operating pressure [bar]
- 280
- Nominal torque [Nm]
- 2285
- Swivelling angle [ degrees° ]
- 120
Similar products from HENSE SYSTEMTECHNIK GMBH & CO. KG
HENSE SYSTEMTECHNIK GMBH & CO. KG
Germany
The output shaft of the HSH swivel motors has radial and axial hydrostatic bearings. Here, radially and axially arranged bearing pockets are supplied with pressurized oil via a separate pressure connection. As a result, the output shaft is centered radially and axially between liquid cushions and all metallic contact surfaces are permanently separated from each other by a thin liquid film. This eliminates wear caused by metallic friction in any operating state, even at zero speed compared to hydrodynamic plain bearings. In conjunction with highly dynamic control valves and angle of rotation sensors, these actuators are preferably used in controlled systems in which disturbance variables such as friction and the stick-slip effect must be reduced to a minimum. Furthermore, due to the lack of internal seals, they are ideal for test series with large numbers of load cycles where an interruption, e.g. due to the replacement of internal seals, is not permitted.
HENSE SYSTEMTECHNIK GMBH & CO. KG
Germany
The L-20 series is a particularly cost-effective solution that is suitable for a wide range of applications. It has versatile mounting options and a flange drive. Helac’s sliding spline technology with helical teeth is not self-locking and offers both high impact resistance and a high holding torque for demanding applications. It functions both as a rotating device and as a mounting bracket and support structure, so that no external bearing systems, brakes or locking devices are required. Available in five standard sizes with an output torque of up to 4,400 Nm at 210 bar.
HENSE SYSTEMTECHNIK GMBH & CO. KG
Germany
The L-20 series is a particularly cost-effective solution that is suitable for a wide range of applications. It has versatile mounting options and a flange drive. Helac’s sliding spline technology with helical teeth is not self-locking and offers both high impact resistance and a high holding torque for demanding applications. It functions both as a rotating device and as a mounting bracket and support structure, so that no external bearing systems, brakes or locking devices are required. Available in five standard sizes with an output torque of up to 4,400 Nm at 210 bar.
HENSE SYSTEMTECHNIK GMBH & CO. KG
Germany
The L-20 series is a particularly cost-effective solution that is suitable for a wide range of applications. It has versatile mounting options and a flange drive. Helac’s sliding spline technology with helical teeth is not self-locking and offers both high impact resistance and a high holding torque for demanding applications. It functions both as a rotating device and as a mounting bracket and support structure, so that no external bearing systems, brakes or locking devices are required. Available in five standard sizes with an output torque of up to 4,400 Nm at 210 bar.