Roof Fan

Renewable energy sources are something that is becoming more relevant every day. Biogas is an alternative and here FläktComp Sweden can contribute with high-quality fans that ensure that the biogas is handled correctly. Biogas fans are a type of gas-tight radial fan, adapted for use in biogas environments where the demands on materials and performance are very high. The fans are usually delivered as a complete unit consisting of fan wheel, motor, cover and vibration feet. In order to choose the right biogas fan, one should start from operating data and process design, as well as whether there are any special requirements.

ATEX fans are fans that are installed in environments where there is a risk that an explosive atmosphere can form. Therefore, these fans need to be designed according to the ATEX directives. Depending on the classification of the environment, internal solutions inside the fan, such as e.g. spark protection in the fan cover or non-sparking materials. While in other cases, EX-rated motors are also required. Explosive gases require special fans. Our factories are certified according to ATEX for the manufacture of fans for Zone 1 and 2 as well as for Zone 21 and 22 containing dust. The design, production and use of fans for explosive media or environment is clearly specified in Europe by standardized directives. To choose the right ATEX fan, one should start from operating data and process design, as well as whether there are any special requirements.

Axial fans are a type of fan that creates airflow through a fan wheel that rotates around an axis and moves the air parallel to the axis. Axial fans can also be called propeller fans and are usually delivered as a complete unit consisting of fan wheel, motor and cover. Typically axial fans are direct driven with the impeller mounted on the motor shaft. There are also other designs such as e.g. belt-driven or with shaft bearing and coupling. The axial fan’s strength is to transport large volume flows at low pressures. At higher pressures, a centrifugal fan may be a better choice. To reach higher pressures with axial fans, these can be connected in series. Usually, the efficiency of an axial fan is comparatively lower than that of a centrifugal fan. But by using guide rails, diffusers and other accessories, an axial fan can reach the same or higher efficiency. The flow of axial fans can be regulated with vane or damper or speed regulation.

Sometimes spare parts are not enough and the entire fan (with or without motor) needs to be replaced. We can help you with all your existing fans. To make the exchange as accurate as possible, we want as much information as possible about e.g. operational data and media. A good start is usually to use the rating plate on your existing fan.