Rotation dampers, steel rotation right, left or both directions
Shock absorbers
Description
Outer body steel. Mounting bush plastic. Version: Steel electro zinc-plated. Note: Rotation dampers are maintenance-free, ready-to-install elements for the controlled braking and damping of rotational or linear movements. These rotation dampers enable the smooth opening and closing of small covers, compartments and drawers. They protect sensitive components and can also raise the quality and value of products. The rotation dampers brake right or left rotations or in both directions. One cycle rate corresponds to one 360° right rotation and one 360° left rotation. Attention: The rotation damper bush should not be used as a support, but rather as an external guide or bearing.
- SMALL METAL PARTS
- Steel rotation
- Controlled braking
Similar products from NORELEM FRANCE
NORELEM FRANCE
France
Industrial shock absorbers are maintenance-free, ready to install hydraulic components. They have an integrated fixed stop. The adjustable version enables precise adjustment to the desired dampening level. After installation, operate and adjust the shock absorber a few times until the desired braking level is achieved. Exceeding the max. energy intake per hour is possible if temporarily disconnected or the shock absorber is cooled with cylinder exhaust air. The installation position is arbitrary.
NORELEM FRANCE
France
Body and flange plate EN AW5754. Guide shafts steel Version Body, hardcoated Flange plates, anodised. Guide shaft, hardened. Note Maintenancefree pneumatic linear modules with two precision steel shafts and ball guide bushing with wipers. Double acting cylinder drive. All fastening threads have threaded inserts. The as accessory available shock absorbers and proximity switches can be integrated (no protruding edges). Positive fit construction for hundred per cent reproducibility. Combinations in all sizes and stroke variants are feasible without adapter plates. Repeat accuracies of ±0.01 mm are possible. Specified loads apply by centred carriages. On request Available with locking cartridge as stroke deviation safeguard. Accessory See table for shock absorber, proximitiy switch and plug connector.
NORELEM FRANCE
France
Unshielded system. The magnets can be mounted by pressfit or gluing. 1) magnetic face
NORELEM FRANCE
France
Hardened to 780 ±40 HV 10 and ground. Without leadin groove. Note All bushes have the bore size marked on the upper face, e.g. 10. Diameters D1 over 15 mm increase in size by 0.5 mm. Dowels or coiled spring pins together with DIN 1731 flathead screws can be used in place of the stop pin.