Work Stops

Micron hand tools are made of high quality stainless steel material. This 4 piece kit contains the cutter and Teflon cutting board used to pre punch the material and the 2 piece setting dies. Specially built to set Stimpson A 670 oblong grommets.

Steel C35Pb. Gunmetal Rg7. Plastic PA6.6 with MoS2). ISO trapezoidal thread based on DIN 103. Steel nuts for adjustments during manual operation and as fastening nuts. Not advised for use with motorised drives due to the steelsteel material combination. Gunmetal nuts for motion drives with low and medium speed. By insufficient lubrication, gunmetal trapezoidal thread nuts on steel spindles have good dryrunning properties. Plastic nuts for lownoise motion drives. Good dryrunning properties. Tolerance class 7H.

Quickrelease couplings for water pipes, oil lines, brake and clutch lines. The quickrelease couplings are always used when a very fast installation and removal of services is required. Areas of application are motorsport and aviation.

Rods for ball bushings and plain bearings Ø10, 12, 16, 20, 25, 30 et 40 mm Guide rods with tapping at both ends (except stainless steel just 1 side) 4 matters hardened steel, chromed steel, stainless steel 304L, hardened stainless steel Several lenghts and special length on request.