Direct acting 3/2 way solenoid change over valve with different orifice sizes for control of neutral gases and liquids. The plunger of the magnetic system is protected by spatial separation from the medium . Valves of this design are single chamber valves with nozzles connections. The coil system can be customised for common voltage and frequency ranges on request. Electrical operating safety is achieved by insulation class F and can be supported by an integrated protective circuit. Due to the use of high quality materials, the valve is applicable for high ambient and medium temperatures. Highly suitable for using in laboratory and analysis equipment. Technical changes reserved.

Product features

Valve body Valve body Part of a solenoid valve, made of plastic or metal, which comprises the in PEI
Plunger guide Stainless steel
Membrane EPDM
Coil coating PBT or epoxy resin
Construction Construction The term construction here is normally referred to the design of a val lever solenoid valve
Ways 3/2-way
mode of operation direct acting
Function flow path P - A normally closed
Fitting position any
Media Cold and heated potable water and physically and chemically similar media
T-Medium 98 °C max.
T-Ambient 70 °C (158 °F) max.
Pressure range Pressure range Nominal pressure or range. a) 0 - 2,5 bar
Cv-value 3,5 l/min @ 1 bar
Coil type MS.006, MS.024, MS.025
Nominal voltages a) 12 V DC
Voltage tolerance +10% -15%
Duty cycle Duty cycle Indicated as ED on equipment nameplates. It refers to the percentage opera 3,5 min OFF: 1,5 min
Nominal power a) 9,5 W (UL approval)
Protection type Protection type Standard which defines the scope of protection of the electromag IP 00 up to IP 68
Coil connections flat tabs 6,3 x 0,8 mm
Insulation class F according to EN 60730
Protection class Protection class Includes statements on measures used to achieve safety of elec I according to EN 60730

Additional product literature


View all the products offered by this company

Need more information from the seller?

Share on: