SEPA EUROPE offers a 40 mm frameless fan especially for embedded systems. It is 10 mm high and provides a compact solution for chip cooling when used in combination with the appropriate heat sink. In addition to the 50 mm frameless fan which is already on the market, the new round 40 mm fan is also a much sought-after model for embedded systems. This is because many standard cooling solutions in this business sector are based on the 40 x 10 mm fan. Strictly speaking, the 40 mm fan has a rotor diameter of 37 mm. The version offered by SEPA EUROPE is equipped with two ball bearings and can boast a remarkable service life of 70.000 h at a temperature of 40°C. In addition to an impulse output for speed monitoring, it also has a PWM input for speed setting in the range of approx. 35 – 100% of the nominal speed. In conjunction with the power block pin-fin heat sink, this virtually silent fan with 22 dB(A) is also available ready for connection in the „Kühligel“ version.
Sweden
Renewable energy sources are something that is becoming more relevant every day. Biogas is an alternative and here FläktComp Sweden can contribute with high-quality fans that ensure that the biogas is handled correctly. Biogas fans are a type of gas-tight radial fan, adapted for use in biogas environments where the demands on materials and performance are very high. The fans are usually delivered as a complete unit consisting of fan wheel, motor, cover and vibration feet. In order to choose the right biogas fan, one should start from operating data and process design, as well as whether there are any special requirements.
Request for a quoteSpain
High flow wall fans for extraction and/or ventilation This type of fans provide significant air flows for the extraction and/or ventilation of industrial, livestock or agricultural premises. Main features - Air flow from 21,000 m3/h to 39,800 m3/h - Structure and overpressure slats in galvanized steel to avoid premature corrosion. - Propellers made of AISI 430 BA stainless steel. - High quality bearings. - IP-55 three-phase electric motor - V-belts. - Transmission pulleys made of magnesium aluminum. - Engine support with tensioner. - Side inserts for easy transport.
Request for a quoteGermany
In the fluid dynamics laboratory of our Wasserburg competence centre, we design new fan wheels and turbines and optimise existing systems for performance, energy efficiency and noise emissions. We also develop complete systems of wheels with power units. Our range of tests includes suction operation, pressure operation and also unpressurised measurements. Revolutions up to 40,000 r/min and diameters of up to 250mm are possible. In our prototype department, we are able to simulate or modify the environmental circumstances of the fan wheels or turbines, thus achieving optimal operational conditions. Furthermore, we carry out mould-flow analysis, use ANSYS from external partners for the flow simulation and establish the fault probability and fault effect with FPFEs. New: Development of blower systems and optimization of ventilation systems.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.