Ant-tte-digit

The usable cutting area is available in multiple sizes allowing to process small to extra-large fabrics rolls. The SM-332-TA reaches speeds of up to 90 m/min with an acceleration of 1G with a motion repeatability +/- 0,1 mm. The cutting area is sectioned to concentrate the vacuum power in specific areas. Pressure bar and side grippers for synchronized movement of the conveyor with the fabric. Motorized conveyor belt to maximize cutting accuracy on long lengths. The SM-332-TA can be equipped with an optional motorized unwind system for large rolls with automatic material alignment control and correction and a digital tension control system.

The preparation of tapes before lamination is often an important step in terms productivity. The new GCM works directly from overlays coils thickness from 0.04 to 0.4 mm with or without magnetic tape. Depending on the machine configuration, the hourly rate reaches 1200 format welded, cut to length and stacked. Benefits Fully automatic suction cup brings a destacker hearts in the process, capacity of 1000 sheets 0.7 mm thick. Cleaning sheets before being fed into the machine, each sheet passes PVC or PET in a special cleaning roller. You do not have to worry about the cleanliness of the cards before lamination. High technology, high precision alignment and positioning hearts compared with magnetic tapes. Depending on the heat size, the magnetic strip can be positioned much higher than the overlay on the bottom. In the assembly process, a special ultrasonic welding of two or three layers fixed with accuracy.

ANY TYPE LARGE SIZE ENVELOPE CLOSE DIE CUTTING FOUR CORNER CUTTING FOR POCKET TYPE AND WALLET TYPE ENVELOPES GENERAL DESCRIPTION Head driven by double chain with frequency converter cushion system to stop at one cutting position with position accuracy ±0.2mm Working capacity up to 400,000 blanks per 8 hours with maximum material stack thickness up to 60mm Die lubrication for clean cuts and longer die life Cutting pad shifter extends pad life Optional adjustable die holder allows for cutting many different sizes of envelope with the same four corner dies, thus saving the cost of expensive dies Maximum blank size 480×550mm (THNC N25) / 600×600mm (THNC N30) Optional pneumatic head center ejector ensures maximum cutting size accuracy for stack material Optional four corner dies Optional front and rear waste removal conveyor belts

Removing the roller tracks by independent heating up to 220 ° C Adjustable speed of laying tracks up to 5 m / min Manual loading of sheets Side guides adjustable micrometer Winding device holder with the magnetic track detection cell in case of breakage. Mounting Tape with voltage control, and adjustable positioning guides the rollers. Positioning + or 0.1 mm servo motor 0,75 KW Cleaning system with a double face support roller on the output Storage formats tracked on a table with two anti static positioned before the guillotine and before the table Touch screen control friendly, multi lingual (French and / or English), setting and trimming various counts Use of electrical, hydraulic and pneumatic standardized Safety guards for strict compliance with CE OPTIONS MTL 700 NSA automatic loading of sheets Roller and additional heating system for a different bandwidth