CETA TESTSYSTEME GMBH

Pressure ranges: -1 bar, +/- 5 mbar, +/- 50 mbar, 200 mbar, 1 bar, 6 bar, 10 bar, 20 bar, 30 bar, 400 bar (high pressure version), negative and positive gauge pressure ranges can be combined. Measuring ranges: ± 500 Pa / ± 5,000 Pa (display resolution: 1 Pa, internal resolution: effectively 0.01 Pa) Result units: Pa, hPa, PSI, Pa/s, hPa/s, mbar • l/s, ml/min, ml/h, l/min, l/h, mmHg, mmWs, Torr Types of test: Standard: Pressure decay Optional: sealed component, dynamic pressure measurement, pressure steps, pressure rise (with double leak connector) Parameters can be exported to a USB stick or imported again. The storage of measurement series and waveforms is possible. Interfaces: Standard: Digital I / O, RS-232 Optional: Profibus DP, Profinet, Ethernet, EtherCAT, Bluetooth, USB Dimensions: 345 mm x 145 mm x 435 mm (W x H x D) In the high-pressure version, leak tests up to a test pressure of 400 bar can be carried out according to the pressure rise method.

The flow tester CETATEST 915 is used for flow testing with compressed air. It includes a measuring system consisting of laminar flow element (LFE) and differential pressure sensor In the direct test method the air, provided by the internal pressure regulator, flows through the measuring section before it enters the test part.In the indirect method, the measuring section is located in the outlet flow of the test part. Due to the special design of the measuring section a laminar ow is generated. The resulting pressure difference is directly proportional to the volume flow. With the optional electronic pressure regulator and four calibrations for up to four test pressures the application range is substantially expanded. Special versions: The CETATEST 915-G is a fully automatic flowmeter for the detection of leaking parts. Typical applications: 915: Testing of valves, vehicle exhaust systems, pipes, membranes, 915 G: Gas appliance industry, after-work jobs in the automotive industry

The CETATEST 715 series includes fully automatic working leak tester for the detection of untight parts within the cycle time of the production process. The leak tester uses a gauge pressure sensor and has a large measurement range. Therefore the CETATEST 715 is especially qualified for the simple testing of parts with large leakages, as they occur in the testing of valves. The test types "sealed component" and "dynamic pressure" can also be integrated. Typical applications: Testing of sanitary fittings, plastic welds, check valves Operating methods: Single-channel operation, two-channel operation The measurements in two-channel operation are synchronous. Measurement ranges: Max. +/-10,000 Pa Result units: Pa, hPa, PSI, Pa/s, hPa/s, mbar*l/s, ml/min, ml/h, l/min, l/h, mmHg, mmWs, Torr Pressure ranges: -1 bar, 200 mbar, 1 bar, 6 bar, 10 bar, 16 bar, 20 bar, negative gauge pressure and positive gauge pressure ranges can be combined.

The CETATEST XS is a compact, fully automatic leak tester for the detection of leaking parts within the cycle time of the production process. The tester is designed for leak testing of small-volume test parts and short total testing times. It is equipped with a gauge pressure sensor, through which the leak-related pressure decay is detected during the measurement time (relative pressure method). Using the application software CETA Soft XS the parameterisation of the test programs is carried out. Measurement results and pressure variation curves can be recorded. Typical applications: Leak tests which require a large measuring range.