The DAIL fulfils the requirements of EN 1114-1 for overpressure protection of extrusion lines and offers maximum comfort of operation. The auto-zero function enables calibration directly on the device or from the observation point/controller. On the output side, the melt pressure transmitter provides a switch output in addition to the analog signal which enables switching off the machine in case of overpressure according to EN 13849-1, PL=c.
Germany
This transducer can be used anywhere thanks to its small size. Designed to work without a measuring chamber (uses a flush front diaphragm instead), this transducer is ideal for any measurements where the material to be measured may leave problematic residues. The range of suitable applications is even greater thanks to a choice of screw-on or weld-on adapters. Areas of use: Bottling plants, food industry Mixing facilities for the chemicals industry Pharmaceuticals Cosmetics industry Bioengineering These miniature pressure transducers are made entirely of titanium and therefore have outstanding resistance to corrosion. These convert the pressure-induced deflection of the diaphragm into a change in electrical resistance, which can be amplified, measured and processed by external electronic circuitry.
Request for a quoteSwitzerland
The differential pressure transmitters of the PD-39X-Ei series measure the pressure difference indirectly using two absolute pressure sensors. The dual-sensor design with numerical differential formation also outputs the line pressure values via the digital RS485 interface and guarantees a high overload resistance. The additional analog current or voltage output is primarily used to output the differential pressure range, which is freely rangeable within the line pressure range. Intrinsically safe – suitable for use in explosive atmospheres.
Request for a quoteGermany
The high-pressure transmitter type DMP 304 has been especially designed for applications with highest demand on precision and reliability. DMP 304 series is based on a compensated strain gauge, bonded onto a stainless steel diaphragm. Due to the rugged stainless steel housing usage under extreme conditions and in IS-required areas is no problem. Features: — nominal pressure: 0 ... 2000 bar up to 0 ... 6000 bar — accuracy: 0.5 % (opt. 0.25 %) FSO — adjustability of offset and span via front sided potentiometers — pressure port 9/16" UNF — 80 % calibration signal with MIL / Bendix plug Optional Features: — IS-version Ex ia = intrinsically safe for gases — pressure port M20 x 1.5 and M16 x 1.5 — accuracy according to IEC 60770: 0.25% FSO
Request for a quoteGermany
The Suvis GmbH offers flat pressure sensors (see photograph), which we produce ourselves and which can be used for classical static pressure measurements on solid surfaces like automobile frames. The flat pressure sensors are applied especially in cases where one cannot place a borehole in the respective surface. Hence, flat pressure sensors represent “transportable” static pressure boreholes, which one can glue on the surface of the flow body. The photo shows typical flat pressure probes. Typical dimensions are 17 mm (diameter of the flat disc) and 0,5 mm as diameter of the pressure borehole. The disc consists of bronze, while the measurement tube is made of high quality steel. In order not to interfere with the flow the discs are chamfered around their periphery. When producing the flat pressure sensors for you we can take your individual design requests into account. Simply contact us for a nonbinding offer.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.