2/2-way solenoid valve of nominal diameter DN 8 for liquid dispense. This valve is direct acting and normally closed (NC). Valves of this design are medium separated seat valves, where the plunger is separated by a diaphragm from the medium. The valve seat is made of scale build up inhibiting PTFE. The internal slope of the inlet reliably redirects air bubbles back into the boiler. This valve can be manufactured with a variety of customised connections in DC or AC voltage. Low power or PPM triggering can be used. Electrical operating safety is achieved by PBT coating of the coil and can be supported by an additional protection circuit. The valve is distinguished primarily by its food grade and hot water capability. Technical changes reserved.

Product features

Valve body Valve body Part of a solenoid valve, made of plastic or metal, which comprises the in PSU
Valve seat PTFE
Plunger guide Stainless steel
Plunger Plunger Plunger describes the part of a solenoid valve which closes the magnetic flux ci Stainless steel
Membrane VMQ
Sealings VMQ
Coil coating PBT, PET or epoxy resin
Type dispense valve
Construction Construction The term construction here is normally referred to the design of a val single-chamber valve inlet ninety degree to outlet
Ways 2/2-way
mode of operation direct acting
Function NC (normally closed)
Fitting position with coil pointing upwards
Media Cold and heated potable water and physically and chemically similar media
T-Medium 98 °C max.
T-Ambient 70 °C (158 °F) max.
DN DN Numerical size indication of the nominal free diameter (diameter nominal) of components fo 8 mm (0.315 inch)
Flow adjustable at outlet nozzle
Pressure range Pressure range Nominal pressure or range. 0 - 60 mbar
Coil type MS.006
Nominal voltages 230 V AC 50/60 Hz
Voltage tolerance +10% -15%
Duty cycle Duty cycle Indicated as ED on equipment nameplates. It refers to the percentage opera AC 50% (cycle 1 min)
Nominal power 9,5 W 16,4 VA (AC only)
Protection type Protection type Standard which defines the scope of protection of the electromag IP 00 higher IP classes on request
Coil connections flat tabs 6,3 x 0,8 mm other connections on request
Insulation class F according to EN 60730
Protection class Protection class Includes statements on measures used to achieve safety of elec I according to EN 60730

Additional product literature

PDF documents


View all the products offered by this company

Need more information from the seller?

Share on: