Drive Pulley - Hot vulcanised
Description
Hot Vulcanized Drive Pulley: The pulley that drives the belt. Prevents abrasion. Coated with rubber to enable the pulley to grip the body of the pipe tightly. With detachable shaft and is connected to the pulley pipe by a clamp system.
A selection of products that might interest you
FTK FÖRDERBAND TECHNIK KILIAN GMBH
Germany
For the special requirements of your belt conveyor system, we manufacture for you drive pulleys, carrying idlers, throbbing drums, lift pulleys with or without internally located cone. With diameters up to max. 1,000 mm and lengths up to max. 4,500 mm, these are suitable for all types of belt conveyor system. All pulleys are turned cylindrically or spherically. The axle connections can be delivered in alternative designs with internal bearings, welded, with wedged connections or with clamping set shaft connections. Special designs such as stainless steel and/or friction linings (ceramic, rubber) and accessories (pedestal bearings) can be delivered upon request.
NORELEM FRANCE
France
The line laser is a measuring device for aligning drive pulleys laterally, horizontally and vertically using a laser beam, preventing heavy wear to the edges of the belt. Laser beam range approx. 5 to 10 m Laser class 2 (EN 6082511997) Wavelength 630–680 mm Power < 1 mW Power supply 2 x 1.5 V (LR44) Note Never look directly into the laser beam and do not point it at other people, animals or strongly reflective surfaces. The device and the target points contain highpowered magnets. Individuals with pacemakers should not use the device due to safety reasons. Keep a safe distance away from electronic devices and wristwatches in order to prevent interference. The device must not be used in potentially explosive areas.
WILLBRANDT KG
Germany
We stock an extensive range of Vbelt pulleys and taper bushes. If you have any questions about types and applications, our experienced staff will be happy to assist you in choosing the right product. - Vbelt pulleys - Standard pulleys - Nubbed pulleys - Flat belt pulleys - Special pulleys - Vribbed belt pulleys - Drive pulley alignment
FTK FÖRDERBAND TECHNIK KILIAN GMBH
Germany
Knocker rolls are used on the cleat belt in order to knock off adhering material. The Knocker roll is fitted in the inner belt near the drive pulley. Area of use cleat belts and badly damaged belts Knocker rolls are used when it is not possible to use conveyor cleaning brushes. They can also be used as combination together with a conveyor cleaning brush.