EQ-VO Vortex Mixer
Vortex Stirrer
Description
This small stirrer is your great ally to prepare a great variety of samples. Mixing liquids is usually required as the prior step to an analysis by ICP or AA. The homogenization of the solid samples with a binding agent is especially recommended for preparing pressed pellets, as well as the correct mixing up of the sample with borates that will later be melted using heat to obtain dissolutions or glass beads.
- Laboratory equipment and instruments
- vortex mixer
- stirrer
- mixer
Similar products from EQUILAB
EQUILAB
Spain
The EQM-402 Mixer Mill is a great ally when preparing samples for analysis, as it can mill, mix and homogenize quickly small volumes of sample. Especially designed for the final preparation of small quantities of hard, semi-hard and fragile samples - up to 50 ml -. This unit is able to prepare two samples simultaneously and to reduce them from an initial size of 0.8 a 1.5mm to a grain size of less than 10μ in a short time – 1 to 4 minutes -.
EQUILAB
Spain
The status of the Platinumware to make glass beads has got a great influence in the final result of the analysis by XRF. Apart from improving and facilitating the time needed to prepare the samples. Equilab introduces EQ-PUL Polishing Unit, especially designed to offer a firm hold of the different pieces so they can be conveniently sanded and polished. This unit can apply up to 8 selectable turning speeds. It is a small, user-friendly and very versatile unit.
EQUILAB
Spain
The great versatility of the new MultiEQP-100 makes of this unit an essencial instrument to treat and make metallic samples. Effective to cut, crush and punch metallic samples, it can also prepare press pellets to be analyzed by XRF. The objective of punching the samples is to obtain pins for their ulterior analysis in Elemental Analizers. The objective of the crushing is to achieve flat surfaces wide enough to undertake spark analysis. The touch-screen and the intuitive software enable the user to control easily the ample variety of operations the MultiEQP-100 features. The two magnetic sensors included in the left hand side of the working units allow the automation of all the working cycles.
EQUILAB
Spain
Today the preparation of metallic samples is undertaken in many and varied ways - depending on the hardness of the metal -. Many times however it is necessary to previously heat the sample to soften the metal and thus facilitate afterwards the processing of the sample, whether by crushing or punching. The EQH-3.0 Induction Heater has been especially designed for heating lollipops and bars to soften them in a minute.