Energy chains, plastic inner height 12 mm, closed - Connectors Energy chains
Description
Polyamide fibreglass reinforced. Version: Black. Closed. Note: Energy supply chains for safe guiding of flexible electric and data cables as well as pneumatic and hydraulic hoses. The modularly constructed chains can be easily shortened or extended. The material is UV-resistant and therefore also suitable for outdoor applications. Technical data: Technical features in unsupported areas: Speed: 10 m/s Acceleration: 50 m/s²
Product information
- Reference
- 80850
- Temperature range
- -30°C to +125°C
Documents
A selection of products that might interest you
NORELEM FRANCE
France
Housing hardened and black oxidised. Contact faces ground. Note: Locating bushes are placed in a fixture or interchangeable subplate and form the counterpart to the locating cylinder. The locating bushes are centred in a reamed hole and then fastened with 4 screws. The balls of the locating cylinder engage in the groove in the locating bush, thereby forming a fast, secure and highly accurate changeover unit, and reducing setup and changeover times. Attention: Please observe installation notes of the locating bushes.
NORELEM FRANCE
France
Workpieces are clamped and released by compressed air. The possible clamping diameter is from 16 to 20 mm. Material: Body, stainless steel. Seal, NBR. Version: Stainless steel bright. Note for ordering: Cylinder head screws M4X35 for fastening from below are included with delivery. Cylinder head screws with low head M5 for fastening from above are not included with delivery. Note: Installed dimensions for plate thickness 6 mm. The stated retaining forces are related to an operating pressure of 0.5 Mpa and a surface quality of Ra 1.6 µm. Repeat accuracy in this case is ±0.2 mm.
NORELEM FRANCE
France
Main body oxidised. Contact faces hardened and ground.
NORELEM FRANCE
France
Body and clamping pin oxidised. Contact faces hardened and ground. Note: The UNI lock 5-axis add-on modules are used for raising basic modules and mounting base. Depending on the clamping situation, optimum assembly height can be achieved using a combination of the basic module and add-on module.