Slide hammer tempered and chromed. Shaft, stop and guide sleeve hardened and chromed. Note: These extractors are used to remove locating pins and centring pins (03105, 03106, 03107, 03108, 03325) with M3 - M8 tapped holes. Drawing reference: 1) stop 2) slide hammer 3) shaft 4) cross pin 5) lock screw 6) guide sleeve 7) cap screw 8) 1 set guide sleeves
France
Indexing pin hardened: Threaded sleeve and indexing pin free-cutting steel Stainless steel version: Indexing pin hardened: Threaded sleeve 1.4305 Indexing pin 1.4034. Mushroom knob black grey thermoplastic. Thread lock blue polyamide. Version: Steel version: indexing pin hardened, ground and black oxidised. Stainless steel version: indexing pin hardened, ground and bright. Note: Indexing plungers are used to prevent any change in locking position due to lateral forces. A new locking position can only be set after the pin has been manually disengaged. Form CP is recommended for applications where the plunger remains disengaged over a long period and the pin should be prevented from springing back. The thread lock enables the plunger to be screwed in to the exact depth required, no spacer ring is required. The thread lock is a gripping polyamide coating that is applied punctiform (spot).
Request for a quoteFrance
Case-hardened, black oxidised and ground. Note: To align fixtures and clamping elements on subplates and palettes with location holes. They can be mounted in holes or slots.
Request for a quoteFrance
Also called fixture clamps. The minimal height of this fixture clamp allows numerous clamping problems in fixture and equipment construction to be solved. The brass hex washer offers a gentle yet extremely stable and safe clamping of workpieces. By using several fixture clamps entire pallets can be set-up. “A” = distance from workpiece to screw centre (cam screw). On request: Replacement cam screws.
Request for a quoteFrance
The double-sided clamp straps are ideal for series clamping. For special applications, the clamping flange can be replaced with another clamping flange by loosening the clamping screw. The clamping flange must always have a contact point on both sides. Functional principle: 1. Use a hand-held or electric tool to tighten the hexagon head bolt (make sure that the maximum tightening torque is not exceeded). When clamping, the clamping flange automatically turns by quarter of a rotation and starts the clamping stroke. 2. Use reverse procedure to loosen the hexagon head bolt. The clamping flange automatically returns to its starting position (the set screw can be used to change the position of the clamping flange). Drawing reference: 1) Hexagon head bolt 2) Slotted round nut 3) Set screw
Request for a quote