FMAMP1K- 1KW FM Pallet Amplifier

The new strain gage amplifier with IO-Link interface enables digitalization of the measurement technology right from the sensor. Its compact design and high degree of protection allow the instrumentation amplifier to be used practically anywhere in the field. Strain gage sensors typically have an output voltage of a few millivolts. In industrial environments, e.g. in the vicinity of electric motors or frequency converters, interference can affect the measurement result when transmitting analog signals. This is reliably avoided using the new strain gage amplifier with IO-Link interface. The analog link between the sensor and instrumentation amplifier is kept as short as possible, the standardized IO-Link communication is fully digital and interference-free. The amplifier is powered directly via the IO-Link interface – a standardized 5-wire cable with M12 socket. Strain gage sensors can be connected via a 4-pin M8 connector.

The TI Instrumentation Amplifier OPA170AIDBVR is a single-channel, low-power, low-noise amplifier with a high common-mode rejection ratio (CMRR) of 90 dB. It has a maximum supply voltage of 36 V and a minimum supply voltage of 2.7 V. The input bias current is 15 pA and the input offset voltage is 1.8 mV. It is packaged in a reel and has a unit weight of 0.001058 oz

Simultaneous speed / torque display universally applicable sufficient for many measuring tasks 11 torque range from ± 0 - 0,5 Nm to ± 0 - 1000 Nm Very short Broad input voltage range Current output and voltage output Measurement accuracy: ≤ 0,5% of full scale Torque ranges from 0,5 to 1000 Nm Contactless transfer of measurement signal Proven strain gage technology Integrated signal amplifier Single power supply Multipurpose use Simultaneous speed/torque indication 4-segment display with sign Peak mode (clockwise only) Indication area on LCD display 30 x 11 mm Speed indication updated 1x sample/second Torque updated 1,000 samples/second