GREENWOOD-POWER

The voltage sensors of Type TxxxB-xx is dedicated to the new T-connector of Euromold/Nexans, called (K) (M)480TB. The T-connectors are usually closed with a dedicated blind plug of a T-connector manufacturer, this could be removed and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED.

The voltage sensors of Type T360Cxx is made for T-connectors with a Type C cone acc. IEC 50181. The Tconnectors are usually closed with a dedicated blind plug of a T-connector manufacturer, this could be removed, and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED. This sensor is especially made for a insulation level of 36kV.

The voltage sensors of Type TxxxC-0U are commonly used in T-connectors of different manufacturers. The Tconnectors ar usually closed with a Type C - Blindplug, this could be removed and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED. The product range -0U is especially made with maximum cost effectiveness by utilizing correction factors.

The voltage sensors of Type TxxxC-xx are commonly used in asymmetric T-connectors of different manufacturers. The T-connectors are usually closed with a dedicated blind plug of a T-connector manufacturer, this could be removed, and the sensor could be installed into this place. The sensor is than connected with the common earth and with the secondary connection cable to an IED. The product range -0U is especially made with maximum cost effectiveness by utilizing correction factors

The A240S-5K voltage detector is a voltage sensor based on a capacitive divider principle. Inside the product there is a high stable capacitor, with a high capacitance and up to 15nF and up to 24kV insulation level. The product is dedicated for air insulated switchgears and could be used also as support insulators with bending forces.

The A240P-5K voltage detector is a voltage sensor based on a capacitive divider principle. Inside the product there is a high stable capacitor, with a high capacitance and up to 15nF and up to 24kV insulation level. The product is dedicated for gas insulated switchgears and is used for asymmetric T-connectors from a range of different manufacturers.

The NxxxR-xx current sensor is dedicated for installation on the bushing of a gas insulated switchgear in the secondary energy distribution. The design is slim and the holding system can be adapted to different kind of T-connectors. Earthing could be done at the current sensor, or through the shielding of the cable or through the S2 connection inside the IED.

The NxxxT-xx current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able, which makes it able to put the sensor on an existing cable. Earthing could be done at the current sensor, or through the shielding of the cable or through the S2 connection inside the IED.

The NxxxE-xx current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able and divided into 3 separate rings, which makes it able to put the sensor on an existing cable. The rings makes it possible to install this product inside switchgears, where the pole distance of the phases can vary up to 1.5m.

The NxxxT-0U current sensor is dedicated for installation on the cables of a gas or insulated switchgear in the primary or secondary energy distribution. The design is split able, which makes it able to put the sensor on an existing cable. Due to cost effective construction, the sensor has a very high cost-benefit ratio.