Miniature centrifugal pump - B - Miniature centrifugal pump - B

Immersion pumps series TH and FH use closed impellers in order to minimize power consumption and to optimize hydraulic pump efficiencies.In addition, the TH series offers high pressures at short immersion depths. Inline pumps of the series FH can be used as boostingpumps if provided with positive inlet pressure. This inlet pressure can be provided by the central coolant supply or a feed pump. In such a setup, pumps of the series FH can raise the incoming pressure by up to 26 bar. Extended length is possible. See mechanical/hydraulic features within the technical information section. Volumetric delivery: up to 640 l/min Delivery head: up to 520 m

Screw spindle pumps with their silicon carbide spindle housing and highly wear resistant spindles are capable of achieving extremely high pressures. Brinkmann high pressure screw pumps are designed for pumping filtered and lubricating fluids such as coolant oils andwatersoluble coolants. High pressure screw pumps are NOT designed for dry-running. Screw spindle pumps are positive displacement pumps which always require the installation of a pressure relief valve in order to prevent bursting. Volumetric delivery: up to 878 l/min Delivery pressure: up to 200 bar

Miniature Centrifugal Pumps of the BMK series have been desined for clean watercircuits of up to 160 degree C fluid temperature and up to 7 bar of system pressure. The pumps are equipped with a magnetic coupling. The pumps can be mounted vertically or horizontally. The specific design allows the pumps to operate wear poor. Impellers: peripheral Types of fluid: Industry water Volumetric delivery up to 55 l/min Delivery head up to 58 m

Cutter Pumps The cutter pumps of the series SFC are capable of cutting aluminium chips and similar materials and pumping of these materials along with the coolant fluid. An agitator located at the pump suction helps to break up and separate any large bundles of chips or birds nests which reach the pump suction. The specially made cutting unit (>60HRC) is cuting chips and the above located semi-open impeller allows with its large clearances to pump the particles along with the coolant fluid from the machine back to the filter. The SFC pumps are capable of handling chip to coolant ratios of up to 1.5% by weight. The SFC pumps are equipped with the user-friendly 45 degree flange connection which allows for either vertical or horizontal pipe connection and the connection of a pressure gauge with G 1/4. Volumetric delivery: up to 1700 l/min Delivery head: up to 45 m