POLYAMID (NYLON 6)
Description
It is a material widely used in machinery industry. It is a material with relatively hardness, rigidness, slippery and good mechanical strength values. There are various uses for its gear applications, including wheel construction. However, it is not as hard and abrasion resistant as Kestamid, not as slippery as Pom C. Its chemical strength is moderate, and it is resistant to some acids and bases. The polyamide 6 has the ability to collect water on its own. These features have pros and cons. Pros is that it increases the strength of the part against vibration and sudden impacts. This allzws the dynamic stresses that would otherwise occur during part use to be removed within itself. Cons is that it is difficult to achieve measurement stability in the material. In other words, the material is affected even by the moisture in the air and gets changes in the measurement. The tolerances must be observed before finishing the final processes of the part.
- Aluminium and aluminium alloys
- Aluminums Metal
- Metal Copper
Similar products from ANKARA BRONZ
ANKARA BRONZ
Turkey
In open air, resistant to fresh and salty water, sulphuric, sulfurous, phosphoric and chromic acids. Affected by acetic formic and nitric acids.
ANKARA BRONZ
Turkey
With a simple fusion, two parts can be combined. Large and heavy parts such as blocks and pipes can be welded using eutectic and tin-lead solder or melting alloys with low fusion points. CORROSION FEATURES Resistant to distilled, salty and fresh water. Affected by strong acids, alkalis and acid salts. Oxygen presence in solution increases response speed.
ANKARA BRONZ
Turkey
Kestlub® is a special cast polyamide developed for bearings. Casting polyamide is produced by adding additives with special processes. Thanks to its internal lubrication, it excellently performs especially in bearing applications.
ANKARA BRONZ
Turkey
It has similar application areas with PVC. It has chemical resistance to acids and bases. It features weldability. Weldability is more difficult than PVC but more resistant weld seams are obtained. It has higher temperature resistance than polyethylene and PVC. Cost is low and economical since its density is very low. It has a high impact resistance. It can be used on section plates. Mechanical strength values are better compared to Polyethylene.