The 16.001.216 pinch valve series is normally open in operation and equipped with a 6 W solenoid coil. Therefore, it exhibits a clamping force of 1,4 N and is applicable for flexible tubes with an outer diameter from 2,2 mm and a shore hardness of 50-60°. With these tubing specifications, pressures up to 1 bar can be switched. The flow of the medium is controlled by pinching the inserted tube. This design avoids using the traditional valve seat and membrane which can cause turbulence in the fluid flow and create dead areas in the valve housing where medium or dirt can collect. The valve is particularly suitable for applications where a high level of hygiene is required. The resistance against chemicals depends on the selected material of the tube. Technical changes reserved.

Product features

Valve body Valve body Part of a solenoid valve, made of plastic or metal, which comprises the in aluminium (surface refined)
Fixing flange PA 66 glass fibre reinforced
Plunger guide aluminium
Plunger and spring Stainless steel
Coil coating PA 6, glass fibre reinforced
Construction Construction The term construction here is normally referred to the design of a val pinch valve
Ways 2/2-way
mode of operation direct acting
Function NO (normally open)
Fitting position any
Media depends on tube
T-Medium 90 °C max. (194 °F max.)
T-Ambient -10 - +50°C (14 - 122 °F)
Pressure range Pressure range Nominal pressure or range. 0 - 1 bar (0 - 14,5 psi) (depending on tube)
Coil type MS.037-16
Nominal voltages 24 V DC
Voltage tolerance ±10%
Duty cycle Duty cycle Indicated as ED on equipment nameplates. It refers to the percentage opera 100%
Protection type Protection type Standard which defines the scope of protection of the electromag IP 65
Coil connections micro
Insulation class F according to EN 60730

Additional product literature

PDF documents


View all the products offered by this company

Need more information from the seller?

Share on: