Power Generation

The decentralized module µCAN.4.ao-BOX features four analogue outputs which optionally provide a voltage signal (+/- 10 V) or a current signal (0…20 mA). The CAN interface supports the protocols protocols CANopen and J1939.Voltage +/- 10 V Current 0…20 mA Accurany 0.05 % (FS) Resolution 16-bit (1 mV / 1 µA) Signal output 1 ms / 1 kHz Galvanically isolated fieldbus Galvanically isolated analogue outputs Signal type freely configurable adjustable scaling Protected against mechanical stress Fieldbus CAN Protocol CANopen / Raw CAN

At its eight outputs the µCAN.8.pwm-BOX provides pulse width modulated signals (PWM) within a range of 0% to 100% for controlling of actuators (valves etc.). The outlets are overload and short circuit protected. The µCAN.8.pwm-BOX is connected with the central control unit via CAN bus.PWM output Basic frequency 40 Hz … 5 kHz Mark-to-space ratio 0.0 % … 100.0 % Galvanically isolated fieldbus Each output to be charged with max. 1.4 A 3-wire connector terminal Output drivers supplied separately Status indication at each output Protected against mechanical impact Fieldbus CAN Protocol CANopen / Raw CAN

From the Idea to Prototyping to Series Production and Evolution – MicroControl plans, develops and manufactures individual solutions MicroControl has more than 26 years of experience in ICA, Bus communication and control technologies. From a variety of different projects we are well aware of the importance of communication and cooperation between all those involved in the project to realize the best solution in due time After a detailed list of technical specifications has been defined in close liaison with the customer, a development plan is created containing time lines and estimated costs. Also, a schedule for prototyping and manufacturing of the series product is established to meet the future lead times, which will give MicroControl customers maximum process reliability. If a non-conformity with the customer’s requirements or any other error is detected, MicroControl will re-design the product without additional costs for the customer to provide the best solution. In any case

Until a vehicle gets road-permission, a number of measurement taske have to be fulfilled along the development chain. During vehicle testing in extreme conditions – in prototyping and pilot series e.g. – MicroControl systems offer the necessary performance and often are an efficient alternative to expensive measurement technology. A variety of different measurement spots in a car can be realized as well as modular test facilities for motors using the 19″ slide-in units.