Powerflex [p1] Und [p2]

The Powerflex protective sleeve helps to effectively increase the friction values of smooth surfaces or to protect the lifting strap against rough surfaces. The particularlyrobust Powerflex penetrates deep into the fibres and also protects the protective sleeve against the penetration of fluids or dirt particles.

Extremely cutresistant contact side Extremely tearresistant contact side. In this version, the lifting strap is coated with two different types. The secutex layer on the contact side is extremely tearresistant. The reverse side is coated with Powerflex. Powerflex prevents abrasion and provides additional protection to the textile against dirt and the penetration of foreign particles

secutex has developed the new “TopDrain” structure surface for lifting wet or oily components. Most of the damages at sharp or rough edges are caused by the movement of the load across the sling. In the case of loads with a “sharp edge” or with a very rough surface, a protective sleeve or fixed coating must be used to protect the textile lifting sling. If the load moves sideways, a cutting movement on the edge is the result. Similar to a knife blade, the edge can cut through the fibers of the textile sling. The new “TopDrain” surface drainage provides good adhesion of the protective sleeves and the coated lifting slings even on wet and oily materials. The liquid can drain off into the surface hollows and the load lies securely in the lifting sling. The “TopDrain” structure works like a drainage and ensures the frictional connection of the secutex coating to the load.

secutex protective sleeves protect loads and textile lifting accessories against marks left by handling. If an edge exceeds the range covered by the norm, the usual textile lifting accessories can no longer be used in conjunction with the secutex protective sleeve. If the edge radius of a load is less than 2 mm, lifting experts refer to it as a “critically sharp edge“. secuwave and secuwave Mini are thicklycoated protective sleeves with a wave structure on the contact side. The wave structure increases the bending radius of “sharp edges”. The edge lies in a wave trough, while the load rests on the wave peak. Therefore, the “sharp edge“ has no contact with the protective sleeve. secuwave is delivered as a clip. This means that it can be subsequently added to a lifting situation. secuwave is available in two versions. The various sizes mean that the suitable wave size can be used. The smaller wave size means that the thick coating is more flexible in the bending direction.