Description

This pump is designed for dispense. The use of the pump allows for flexible siting of dispense valves inside the machine, including up to approx. 0,4 metre (15,7 inch) above the water level in the boiler. Varying the voltage supplied to the pump will change ist speed and thus vary the flow rate output. The impeller is driven by a longer shaft which locates the motor 58 mm above minimum fill level of the boiler. The pumps body housing is suitable for use with hot water. Technical changes reserved.

Product features

Sealings EPDM
Pump housing PEI
Impeller PEI
Type pump
Construction Construction The term construction here is normally referred to the design of a val centrifugal pump
mode of operation not self priming
Fitting position Motor upwards
Media Cold and heated potable water and physically and chemically similar media
T-Medium 95 °C max.
T-Ambient 70 °C (158 °F) max.
DN DN Numerical size indication of the nominal free diameter (diameter nominal) of components fo 5 mm
p-max (16 V DC) 102 mbar (1.48 psi)
Q-max (16 V DC) 3.6 l/min (0.95 gpm)
p-max (26 V DC) 71 mbar (1.03 psi)
Q-max (26 V DC) 3.0 l/min (0.79 gpm)
Motor type direct current motor
Nominal voltage Nominal voltage Voltage for which the valve is designed. A fluctuation range fro 12 V DC (power supply)
Voltage range 10-16 V DC
Duty cycle Duty cycle Indicated as ED on equipment nameplates. It refers to the percentage opera 100%
Protection type Protection type Standard which defines the scope of protection of the electromag IP 00 according to EN 60529
Motor connections Tyco 280609-2
Basic interference suppression Capacitor across terminals
Insulation class B according to EN 60730
Protection Class III according to EN 60730

Additional product literature

PDF documents

OTHER PRODUCTS FROM THIS COMPANY

View all the products offered by this company

Need more information from the seller?

Share on: