Setting Ring 2mm KINEX, DIN 2250C

The compact ECO2-Ei digital manometers are budget-friendly and provide a good resolution. The minimum or maximum value since the last reset can be displayed at the same time as the current pressure value in a wide variety of units of pressure. The swivel adapter allows the device to be optimally positioned. Power is supplied by a conventional CR2430 coin cell battery (provided). Intrinsically safe – suitable for use in explosive atmospheres.

Housing fibreglass reinforced thermoplastic polyamide. Sight glass thermoplastic polyamide. O-ring and flat seal NBR. Reflector PVC. Float plastic. Screw and nut, steel. Version: Housing black. Sight glass crystal clear, high mechanical stability, non-ageing. Reflector white. Float red, with magnetic element. Screw and nut electro zinc-plated. Note: The oil level gauge not only enables the oil level to be viewed but also recorded using a REED switch. In addition, the oil level gauges can also emit an electric signal if the temperature of the liquid inside the container reaches the threshold of 70 °C. As soon as the float element approaches the selected minimum value after the circuit has been closed, the system emits an electric signal. The sensor is located on the housing and its height can be adjusted in line with the control requirements for the oil level. The minimum level is ca. 35 mm from the centre of the lower fastening screw.

Innovacera developed a series of ceramic accessories for Inside Micrometers, Holtest and Dial Bore Gages. The ceramic material used mostly is zirconia. The zirconia ceramic setting ring advantages: Used for quick and accurate setting of dial bore gages, Holtest, and inside micrometers. If a setting ring of an optimal size is prepared, it can be used for calibration. Actual inside diameter is marked on each ring No more anticorrosion treatment is required when handling Ceramic Setting Rings normally, resulting in simple maintenance and storage. The Zirconia Ceramic Ring Gauges tolerance: Tolerance between the nominal size and the actual diameter: 0.001mm for 1-45mm DIA. setting rings Cylindricity: 0.001mm for 1-45mm DIA. setting rings Some Zirconia Ceramic Ring Gauges Innovacera made: 9mm, 10mm, 18mm, 20mm, 24mm, 25mm, 28mm

Although control and measurement devices (tests) should and most often are used in a very safe way, they still require cyclical measurement control and regeneration and possible calibration in order to obtain the required measurement accuracy, reliability and repeatability. Ensuring the stability and certainty of quality control - in this case control measurements - translates directly into the quality of manufactured parts and related possible complaints, repair costs and / or service actions. In order to avoid such situations, it is necessary to take care of the impeccable condition of the measuring instruments. Therefore, both in the event of a fault on the gaugecaused by a mechanical factor, related to an accident or an unfortunate coincidence, as well as in the case of the approaching time of cyclic calibration, which, depending on the conditions and intensity of use of the test, should