Single Row Track Rollers
PERFORMANCE BEARINGS
Description
Track rollers—also referred to as idler rollers—are motion transmission components designed to work with all varieties of tracks. They are used in conveyor systems, cam drives, and a wide range of similar material handling systems. Regardless of the material or machine, these components play a critical role in track and rail operations. When selected, employed, and maintained properly, they facilitate system operations, allowing for greater speed and efficiency. Single row track rollers are available with spherical outer ring running surfaces or cylindrical (or flat) outer ring running surfaces. View our page of Special Profiles found under Technical Parameters for some of the more common profiles on the running surface.
- Bearings, ball
- track rollers
- rollers
- Rollers Track
Documents
Similar products from WIB SA
WIB SA
Switzerland
These track rollers offer the same features of a single row track roller with the added benefit of heavy radial, thrust or combined loads. Yoke-type track rollers are single or double-row units mounted on shafts or studs. Similar to the single row track roller, we can customize the running surface to meet the specific requirements of the applications. Cam rollers are similar in their construction to single and double-row support rollers, except that the raceway is formed by a heavy-section roller stud with a fixing thread. The most common running surface profiles can be found on the Special Profiles page under Technical Parameters.
WIB SA
Switzerland
The manufacturing precision of the roller has a major influence on the quality of the final product (wires) as well as on the service life of the rollers. It is therefore essential that the ground “V” groove on the outer ring is machined and positioned precisely relative to the internal geometry. WIB only produces straightener roller bearings produced in this fashion, while many other producers machine the outer wire guide groove after assembly
WIB SA
Switzerland
Self-aligning ball bearings have two rows of balls, a common sphered raceway in the outer ring and two deep uninterrupted raceway grooves in the inner ring. This type of ball bearing is recommended when alignment of the shaft and housing is difficult, and the shaft may flex. Unlike a single row or double row ball bearing, the self-aligning bearing’s performance will not be affected by misalignment. Therefore, they are particularly suitable for application where misalignment can arise from errors in mounting or shaft deflection inherent in the application. These bearings are made with seal or without seal.
WIB SA
Switzerland
Double-row angular contact ball bearings are used in applications when heavy radial, thrust or combined loads demand axial rigidity of the shaft are required. This is similar to a duplex pair of single- row bearings due to its two rows of balls and angular-contact construction, which provide greater axial and radial rigidity than can be obtained by using a single-row radial bearing. We manufacture these ball bearings with a minimum bore diameter of 3 mm to a maximum outer diameter of 47 mm.