The model TNZ ZCAF is composed from the coupling halves of the coupling TNZ ZCA and is complemented by an intermediate shaft and two rigid counter-flanges. If required, the torsional stiffness of the shaft can be tuned to the dynamic behavior of the drive line. In addition, the intermediate shaft, which serves to accommodate longer shaft separations, can be mounted and dismounted radially without having to move the connected machines. TNZ ZCBF: Double engagement design with a bolt-on O-ring carrier for ease of installation, and an intermediate shaft to fulfill specific requirements in terms of torsion spring stiffnesses The model TNZ ZCBF is composed from the coupling halves of the coupling TNZ ZCB and is complemented by an intermediate shaft and two rigid counter-flanges. If required, the torsional stiffness of the shaft can be tuned to the dynamic behavior of the drive line. In addition, the intermediate shaft, which serves to accommodate longer shaft separations, can be mounted and
Turkey
Delrin gear parts are high-performance components made from a specialized thermoplastic material known as Delrin, or polyoxymethylene (POM).
Request for a quoteTurkey
The rotation of high speed shaft should not be more than 1500 rpm; The circumferential velocity of gear tranmission should not be more than 20 m/sec; The temperature of work environment should be -40-45°C. If it below 0°C, before start, the lubricating oil should be pre-heated to above 0°C. This speed reducer can be run at clockwise and counterclockwise direction.
Request for a quoteTurkey
With our extensive supplier portal, we can cover all your needs in the field of Gears and Bevel Gears. Trust us in choosing the right supplier for your needs
Request for a quoteFrance
Milled toothing, straight teeth. Engagement angle 20°, bright. Note Up to 70 teeth with hub one side, from 80 teeth supplied as disc form. The spur gears have a centre bore or pilot hole (this can vary due to manufacturing methods). For this reason, the dimension D2 max. given in the table is the maximum diameter of the bore with which the spur gears are supplied. This pilot/centre bore can be amended by the customer to produce a reamed bore, reamed bore with keyway or a tapped hole. Alternatively, customers can also use bushes to reduce the bore diameter. Drawing reference Form A with hub Form B without hub
Request for a quoteCreate one request and get multiple quotes form verified suppliers.