VCP

Cyclo-filters are devices, which are applied mainly in the heat industry to de-dust grate boilers. We apply them in order to warrant dust emission not exceeding 100 mg/Nm3 for 6% O2. ADVANTAGES Low investment and operational costs compared to bag filters and electro-filters The highest quality elements characteristic High efficiency of de-dusting< 100 mg/Nm3 for 6% O2 Long shelf-life of a unit Possibility of partial re-circulation of purified fumes to a boiler in order to reduce on O2 and NOx Guarantee of expected emission rate of dust and reliable operation of the dust extracting system ensured by filtration area adjusted properly to the boilers de-dusting process

CF 30 G equipment is supplied completely assembled and ready for operation. The dust collection unit is suited for intermittent operation only, because regular cleaning of the pocket filter element in certain intervals is an absolutely must for the proper operation of the equipment. The cleaning intervals will depend on the operating conditions and must be established by experience. Normally cleaning intervals will be between operating times of 30 minutes to two hours. It is a prerequisite for sufficient and intensive cleaning of the filter cloth that dust collecting is interrupted during cleaning to achieve static pressures on the filter material. A retention time of 1 - 2,5 minutes between the end of the suction and the beginning of the cleaning process is therefore required. The filtered air must be removed outside - do not lead back to closed rooms!

TECHNICAL DETAILS Interior ready-to-use smooth finish coating, easy to apply - requires less sanding down than a traditional coating and therefore creates less dust. Apply with spatula, then sand down. Less dust is created, and the dust is less volatile. SUITABLE SURFACES Interior walls and ceiling : plasterboards, gypsum blocks, concrete, cement coating, aerated concrete, sealants. REFERENCE DOCUMENTS DTU 59.1. PACK SIZE 25 kg bucket. AFNOR NFT 36.005 AMOUNT REQUIRED From 0.6 to 1 kg/m² depending on quality of surface. DRYING TIME 6 to 24 hours depending on conditions and quantity applied. RECOMMENDED APPLICATION To avoid all traces of filler, finish with a slightly rounded action.

Continuous dust monitoring in ambient air control system areas, silo areas, boiler houses, workstations. AirSafe 2 is an electrodynamic dust sensor monitoring leakages and dust concentration in ambient air in production facilities or workplaces. This versatile sensor allows you to keep under control your ambient environment. An alarm is generated when a threshold is exceeded. • controlled and selfmonitored system • calibratable alarm • prevents creation of dust explosion zones • dust concentrations in the ambient air are safely monitored • AirSafe 2 can be used as early detection for dust which could endanger the workplace adapted for applications in zone 22 dust • possible dust leakage from the process is quickly detected