VGS 4500
Vehicle Gas Scout 4500
Description
The new Scout VGS 4500 measuring station consists of measuring probes mounted on the front of the vehicle and a measuring cell installed within the vehicle. These two parts are connected via a suction hose. The system can be mounted on different type of vehicles such as a pickup truck, quad or car. To adapt to nature of the surface to be measured, the probe distance can be adjusted quickly and it is just as easy to store the entire front probe. With the Scout VGS 4500 measuring station from Schütz, very large sections of network can be inspected and the results can be recorded in a short time. With the vehicle-based measuring system, measurements are accurately taken at speeds up to 50 km/h. Even under the most difficult conditions, Scout VGS 4500 has proven its reliability. The system was successfully subjected to a resistance test in the desert at an outside temperature of over 36 degrees Celsius.
- Measurement and control instruments
- Vehicle-based measuring
- probes
- Measuring station
Product characteristics
- Sensor
- laser spectroscopy
- Measuring range
- 0,01- 20,000 ppm CH4 (methane) in air
- Minimum sensitivity
- 0.01 ppm
- Maximum measuring speed of the vehicle
- 50 km/h
- Operating temperature
- -10 °C - + 50 °C
- Ambient temperature measuring cell
- 10 °C - + 30 °C
- Protection class
- IP 54
- Power supply
- 12V
- Humidity
- 0% - 90% r.h. non-condensing
- Housing
- stainless steel
- Dimensions
- 900 x 250 x 245 mm
- Weight
- 32 kg
- Interface
- LAN, USB
Similar products from SCHÜTZ GMBH MESSTECHNIK
SCHÜTZ GMBH MESSTECHNIK
Germany
For measuring gas concentration in shafts or just below the ceiling.
SCHÜTZ GMBH MESSTECHNIK
Germany
The accessibility of the lines for pressure tests in industrial companies is often a major problem, but no longer with this probe!
SCHÜTZ GMBH MESSTECHNIK
Germany
The accessibility of the lines for pressure tests in industrial companies is often a major problem, but no longer with this probe!
SCHÜTZ GMBH MESSTECHNIK
Germany
Weight-optimized bell probe with carbon fiber rod and integrated filter technology. Extremely light, yet very robust construction for fatigue-free work. The bell probe has a dust and a water filter integrated in the lower section and is used for unpaved surfaces. When the carpet probe can no longer be used, the bell probe is used for above-ground control or for concentration measurement in the ppm range. Both probes are often carried along; the CFRP mini bell probe is ideal for this. The Bell Probe CFRP Mini is particularly suitable for carrying along with the carpet probe during pipeline network inspections. The Bell Probe Mini is clicked into the rod of the carpet probe. Together with the Carpet Probe CFRP, the combination of both probes weighs less than a metal constructed probe, with the same or higher strength.