Venting element JDAE made of polyamide

Waterproof enclosures with protection grades IP67 or IP68 for outdoor use are not automatically sealed against vapour and humid air. To avoid negative pressure, high humidity and condensation inside the enclosure a continuous Ventilation and pressure equilibrium is necessary. This function can be achieved by using a venting element made by Jacob. Features: - Continuous ventilation and adaptaion on the inner pressure - Hydrophobic and oleophobic PES- membrane - Body from stainless steel 1.4305 - Theoretical air flow through usable surface up to 75 l/h at Delta-p = 0,07 bar - Water entry pressure >= 0,83 bar (dynamic WEP, 30 seconds) - Temperature range -40°C / +100°C - Protection grade IP66 / IP68 - 0,6 bar (60 min.) / IP69

Application in electro enclosures. Features: - Continuous ventilation and drainage of the enclosure - Pressure equalization between enclosure and outer atmosphere - Reduces condensation - Polyamide PA6 V-0 - Temperature range -40°C / +100°C - Protection grade max. IP65 Vertical installation at the lowest point of the enclosure bottom so that condensation water can drain off via the breather.

The PERFECT AirVent cable gland: protection for hermetically sealed electro-technical and elecronic enclosures against condensation water from alternating temperature and pressure. Features: — continuous ventilation — adaptation of the inner pressure — water entry pressure of the Membrane > 0,2 bar — available in sizes M12, M16 and M20 — for cables from 2 to 13 mm — temperature range -20 °C / +100 °C (dynamic) — protection grade IP66 / IP68

The PERFECT AirVent cable gland: protection for hermetically sealed electro-technical and elecronic enclosures against condensation water from alternating temperature and pressure. Features: — continuous ventilation — adaptation of the inner pressure — water entry pressure of the Membrane > 0,3 bar — available in sizes M20, M25 — for cables from 5 to 16 mm — temperature range -20 °C / +100 °C — protection grade IP66 / IP68