optical sensors - OG500572

— High switching frequencies up to 1000 kHz — Fully encapsulated versions to protection class IP67 — Sturdy metal enclosure — Temperature range: -25°C up to +70°C — Sensing distances: 5 mm up to 16 mm — 10 – 36 V DC or 20-250 V AC — PNP / NPN versions — NO / NC versions — Cable / connector versions — Function indicators — Short circuit-proof versions — Versions with IO-Link

The new strain gage amplifier with IO-Link interface enables digitalization of the measurement technology right from the sensor. Its compact design and high degree of protection allow the instrumentation amplifier to be used practically anywhere in the field. Strain gage sensors typically have an output voltage of a few millivolts. In industrial environments, e.g. in the vicinity of electric motors or frequency converters, interference can affect the measurement result when transmitting analog signals. This is reliably avoided using the new strain gage amplifier with IO-Link interface. The analog link between the sensor and instrumentation amplifier is kept as short as possible, the standardized IO-Link communication is fully digital and interference-free. The amplifier is powered directly via the IO-Link interface – a standardized 5-wire cable with M12 socket. Strain gage sensors can be connected via a 4-pin M8 connector.

The bus-compatible AP10 position indicator serves for monitored format adjustment in order to reduce setup times and enhance machine efficiency.Readability has been optimized to achieve intuitive user guidance. The backlit display clearly indicates target and actual values  two-row position indicator for representing target and actual values and the two LEDs clearly show the direction to be set.  Electronic position indicator with bus interface. Stainless-steel hollow shaft ø20 mm, up to ø25.4 mm as an option. Backlit display. Two-line LCD for target and actual values. Reset, incremental measurement, offset via keyboard. Integrated RS485 interface, CAN bus or IO-Link as an option. Robust sensor technology unit thanks to magnetic scanning. User guidance through status LEDs. Mechanically compatible with the DA09S position indicator. IP53 type of protection, IP65 as an option.

The new QuellTech Q5 Laser Scanner Series combines the advantages of small form factors with both high resolution and scan rate. The sensor disposes of different set-up possibilities with respect to the analysis algorithm. Measurement results are delivered via Ethernet, calibrated in the X / Z plane. Special adjustable algorithms can be selected, extremely useful particularly also for optically most demanding surfaces. Time-consuming calibration tasks for the user are no more required, as the calibration routine runs on board. High Scan Rate with up to 14,000 Profiles per Second Due to an appropriate limitation of the image range (AOI) in X and Z direction, the scan rate could considerably be increased. High resolution and detection frequency with up to 14.000 profiles and 28 Mio. points per second •X measuring range from 10 to 1022 mm •Z measuring range (height) from 5 to 878 mm •Laser wave length blue 405/450nm, red 650nm