AAAGILER GMBH WAAGENVERLEIH

The new strain gage amplifier with IO-Link interface enables digitalization of the measurement technology right from the sensor. Its compact design and high degree of protection allow the instrumentation amplifier to be used practically anywhere in the field. Strain gage sensors typically have an output voltage of a few millivolts. In industrial environments, e.g. in the vicinity of electric motors or frequency converters, interference can affect the measurement result when transmitting analog signals. This is reliably avoided using the new strain gage amplifier with IO-Link interface. The analog link between the sensor and instrumentation amplifier is kept as short as possible, the standardized IO-Link communication is fully digital and interference-free. The amplifier is powered directly via the IO-Link interface – a standardized 5-wire cable with M12 socket. Strain gage sensors can be connected via a 4-pin M8 connector.

The Trotec PC200 Particle Counter features 6 measuring channels (0.3, 0.5, 1.0, 2.5, 5.0 and 10.0 μm) with three counting modes (concentration, cumulative and differential) and counting efficiency of 50% at 0.3 μm and 100% for particles beyond 0.45 μm. The internal pump allows flow rate of 2.83 l/min (0.1 ft³/min) and the zero count is < 1 particles / 5 min with a coincidence loss of 5%, 2 million particles per ft³ (28.3 liters). The Laser class 3B with wave length of 780 nm and 90 mW is used as a light source while isokinetic probes serve as sample inlet. The device can be used to easily acquire readings on air temperature, humidity, dew point temperature and wet-bulb temperature.

The T610 is a handheld measuring instrument from the Trotec MultiMeasure family, used for quick non-destructive moisture measurement up to 300 mm. Another advantage of the process, aside from the measuring depth, is its independence from the level of salt content in the material. This creates no dissimilarity to the microwave technique, whether it is an older or a new building being gauged. Since the unit’s screen can show two values, for purposes of results evaluation, a function value can be indicated at the same time as the present measured value, if needed. The T610 moisture meter can be linked to a PC through a USB cable. Due to the MultiMeasure Studio Software, the gauged values of the device can be transported online and in real time to the PC. A few practical benefits: German industrial design in robust, premium two-component construction with IP54 type of protection

The Cairsens© H₂S / CH₄S sensor allows specific pollutant measurement comparable to reference methods.