DOWEL TECHNOLOGY

Metal dowel for hollow structures The main purpose is to attach building materials to bases with low loadbearing capacity, for example: plasterboard, particle board or hollow materials. It is also used when frequent disassembly of the structure is necessary. Installation can be carried out in two ways: using special pliers, using a screwdriver.

Dowel for insulation materials with plastic/ metal nail The main purpose is to attach thermal insulation materials to concrete masonry. It is used for mounting on walls that are particularly exposed to the adverse effects of atmospheric conditions. Material: dowel - HDPE (low pressure polyethylene); nail - impact resistant polypropylene/galvanized metal Starting from a length of 140mm, it is recommended to use a metal nail. Per 1 sq . m . 4-5 dowels are recommended for mounting insulation. The dowel for insulating materials has a unique distinctive feature - on The inscription OMAH is stamped on the surface of the hat.

Driva dowel, plastic / metal with a drill bit The main purpose is installation in a plasterboard wall. With a drill bit, it is screwed in without pre-drilling. The design of the dowel prevents its spontaneous unscrewing and ensures fastening without straining. After installation , the material is attached to it with a screw. If necessary, it can be turned out of the wall.

The Butterfly dowel is mainly used for fastening lightweight structures in plasterboard and other thin-walled structures. Due to the special design, the dowel is blocked already at the moment of deposition. Full locking of the dowel is achieved by tightening it with a screw. It is very important to select the appropriate length of the screw, since the dowel is tightened with a screw from the end to the beginning. Material: HDPE (low pressure polyethylene) The butterfly dowel has a unique distinctive feature - the OMACH inscription is stamped on the side surface.