Locating pins with internal thread
Rest pads and positioning feet
Description
Hardened and ground (HRC 60 ±2). Note: The locating pins are designed to make the joining process easier. Used in combination with hardened locating bushes 02026, they enable exact, low-wear, and fast changes of the workpiece. Versions D1 = 5 and D1 = 6 do not have an internal thread. Drawing reference: Form B: cylindrical pin Form C: rhomboid pin
- Screws
- Pins locating
- Internal screw
Product characteristics
- Reference
- 02025
- Material
- Steel
- Form B
- cylindrical pin
- Form C
- rhomboid pin
Documents
Similar products from NORELEM FRANCE
NORELEM FRANCE
France
Form A locating pins are used to position workpieces and fixture parts in reamed holes. The flattened Form C can be used to bridge tolerances in hole spacing or to secure the part to be positioned in one direction only. The Form A locating pins can also be used as limit stops or fixture feet. Advantages: Cerazur is extremely impact and bend resistant. The basis of this material is zirconium oxide. It is a composite metal-ceramic material. Drawing reference: Form A and B: cylindrical locating pin Form C and D: flattened locating pin
NORELEM FRANCE
France
Hardened and ground (HRC 56 +2). Note: The locating pins can be easily removed with an extractor.
NORELEM FRANCE
France
Ball end locating pins are specially designed to ease the locating process. The tendency to jam, caused by the locating hole not being at right angles to the pin or by the pushing force not being parallel to the pin axis, is minimized by the ball-end form (see illustration).
