Permanent magnetic block - MBX

Plate-spreading-magnets are used for separating of stacked iron and steel sheets. The sheet separators are laterally grown from the sheet stack, they magnetize the sheets with the same poles, which repel them from each other. Plate-spreading-magnets apply both in automated systems where plates with vacuum or transshipped are magnetic, and the manual work, where the gripping sheet is greatly facilitated by their help. Our Plate-spreading-magnets consist of a reinforced magnet system, which is installed in a stable sheet steel housing.

The FX-HV Horizontal-Vertical System will meet with its diverse setting almost any need. Overall height and focus can be adjusted by plug pins. Likewise, the device also can be used for up to 20% of its rated load without engaging under pads.The support pins are positioned in a way so that standing blanks can be struck, which, for example, is often required on the saw. Likewise lying discs and sheets can be placed. For horizontal transport, the system has a lifting eye on the back. The steel structure is completely coated, and the stable FX Lifting magnet ensures maximum safety. Special dimensions are available on request.

FX-C lifting magnets have a round, multipole clamping surface, designed for lifting rings, sleeves, bearing housings, flange plates and similar workpieces.The load specification is valid for full-surface mounting on workpieces which cover D inside to D outside (see table Dimensions), for workpieces with a smaller mounting surface an approximate maximum workpiece weight of 3.5 kg per cm² clamping surface can be calculated. For serial workpieces, a documented test should confirm the safety factor 3.

Pneumatically actuated magnetic gripper type PNEUMAG are pneumatic switchable bi-stable magnetic systems. Air pressure is only needed for switching. The magnet system is permanent and thus keeps safe even with pressure drop. PNEUMAG magnetic grippers enable thin, perforated or textured sheet metal parts (from 0,5mm) take and safe to transport what they recommended specifically for use in automatic and semi-automatic feeding systems as well as slings for robot grippers. PNEUMAG is the alternative to vacuum conveying systems. They were tested on a metal sheet St37 with smooth and clean surface. Note that depending on the application a safety factor of 2 or 3 has to be included.