Plain bearings plastic
Plain bearing
Description
Highperformance polymer iglidur® G, iglidur® J or iglidur® X. Version iglidur® G grey; iglidur® J yellow; iglidur® X black Note Plastic highperformance polymer plain bearings. – maintenancefree – lubricantfree – corrosionresistant – resistant to dirt – high dimensional precision – high pressure resistance – good heat dissipation – very low creep tendencies – high mechanical damping – resistant to UV radiation. Assembly The bearings are designed for press fits in H7 bores. After pressing in, the ID of the bearing will be diameter D with the relative tolerance. The bearings are suitable for shafts with h tolerance (recommended min. h9).
- Universal joints
- Bearings plastic
- bearings
Similar products from NORELEM FRANCE
NORELEM FRANCE
France
Housing anodised aluminium. Bearing surface Frelon (Teflon plus proprietary fillers). Virtually chemically inert. Selflubricating (no additional lubrication required). High temperature range (240 °C to +260 °C). Dampens vibrations. High static load capacity projected surface area x P (P = 1034 N/cm²) Suitable for food, pharmaceutical, medical and chemical applications. Insensitive to dirt.
NORELEM FRANCE
France
Housing igumid® G. Swivel ball iglidur® W300 Note The ability to pivot allows pillow block bearings to compensate for misalignment and possible shaft deflection. They are easy to install and suitable for the accomodation of rotating, oscillating and linear movements. igubal® pillow block bearings are maintenance free and conceived for dry running condition. Assembly These pillow block bearings are designed for mounting with 2 screws. The ID tolerance is E10. The matching shaft should have a tolerance of h6 to h9.
NORELEM FRANCE
France
Universal joints with plain bearing can be swivelled by 45°. Max. transferable torque (Nm) at 150 rpm, operation angle α < 5°. * Bore depth is less than by DIN 808.
NORELEM FRANCE
France
Bearing block and carriage aluminium alloy. Guide column and threaded spindle stainless steel. Plain bearing for guide columns and spindle nut highquality special plastic. Claw coupling aluminium with polyurethane coupling spider. Version Aluminium alloy anodised. Stainless steel hardened and ground. Threaded spindle with ball bearing. Note for ordering The unit is supplied with the position of cable outlet or control unit as shown in the drawing. Note Positioning stages for motorised adjustment and positioning tasks. The plain bearings and spindle nuts are suitable for dry running, however lubrication with a grease for plastic plain bearings is recommended. The suitable programming software and interface cable for the stepper motor with positioning control are available as accessories (2500015).