Torque Wrenches

The transducer is suited for the most varied measurement duties on threaded fasteners, to check and adjust assembly tools, like screwdrivers and spanners, and to sense loosening torques, etc. It can also be deployed in blocked mode to test torque wrenches. The device is powered wirelessly and the electrical output is wireless, as well. Hence, there is practically no wear on the device. This sensor is suited for cyclical as well as continuous testing of tools. As the sensor is designed to be torsionally rigid any errors due to it are minimized. No service needed because of contactless data aquisition High interference immunity due to amplified active signal High accuracy due to frequency modulation and strain gage technology Power supply Optional angle detection torque ranges from 1 Nm up to 10.000 Nm torque with square drive with or without angle (w) function Variant bracket for quick assembly

The most accurate digital torque tester with Fail Safe Engineering! - Greater accuracy and durability with simplicity and ease of operation - Floating decimal point, 6 digit display is easy to read - Accurate to ± 0.25% (indicated value) from 10% to 100% - Over capacity alert and tracking System 8 error proofs your error-proofing program by letting you know when the unit has been stretched to 120% or more of capacity and may no longer be in calibration. System 8 has an LED that flashes red to alert you to the problem. It doesn’t stop until you reset the unit. The display also tells you the unit has been stretched over capacity. System 8 captures the over capacity data even if the memory was turned off. If memory was turned on and the unit is pulled over 120% capacity and a worker tries to erase the memory to stop the LED from flashing, the display tells the worker to “See Supervisor 120% Over Capacity”. No other torque tester on the market does this.

Torque range; 40 – 210 Nm  Extension bar 250mm  3x deep impact socket  17mm  19mm  21mm

The new strain gage amplifier with IO-Link interface enables digitalization of the measurement technology right from the sensor. Its compact design and high degree of protection allow the instrumentation amplifier to be used practically anywhere in the field. Strain gage sensors typically have an output voltage of a few millivolts. In industrial environments, e.g. in the vicinity of electric motors or frequency converters, interference can affect the measurement result when transmitting analog signals. This is reliably avoided using the new strain gage amplifier with IO-Link interface. The analog link between the sensor and instrumentation amplifier is kept as short as possible, the standardized IO-Link communication is fully digital and interference-free. The amplifier is powered directly via the IO-Link interface – a standardized 5-wire cable with M12 socket. Strain gage sensors can be connected via a 4-pin M8 connector.