Structures- aluminium - Import export

The connecting sets are used to connect two aluminium profiles at right angles. They allow free position of the profiles. The profile slots positioned at rightangles to each other remain free. Panel elements can be positioned in the profile slots without additional machining. Due to the reduced clamping force and omitted rotation locks, these connecting sets should only be used in combination with panel elements and lightly loaded constructions. Low workload. To assemble a hole must be drilled into one of the profiles. The D2 hole can also be drilled through.

The aluminium profile is matched to the roller elements. As a result, roller rails and roller tracks can be realised. The different inserts permit modular and flexible setup.

Lightweight aluminium profile for weightoptimised constructions.

The aluminium profile is matched to the roller elements. As a result, roller rails and roller tracks can be realised. The different inserts permit modular and flexible setup.

Aluminium profile for general structures. The round tube, also referred to as a profile tube forms a feed roller when used in combination with bearing flanges (10400).

Lightweight aluminium profile for weightoptimised constructions.

The connecting sets are used for connecting two aluminium profiles at right angles. The connection is nonrotating. For larger profiles several connecting sets can be mounted on the end for greater strength Low workload. Cut a thread in the end face core hole. Drill a through hole for tightening the screw in the opposing profile.

Slot key, grub screw and serrated washer, steel. Nut and washer, brass. Version Slot key, grub screw and serrated washer, electro zincplated. Note For protecting installations and persons. Connectors for earthing aluminium profile structures and interconnecting the aluminium profiles by integrating them into the protective earth (PE) system. Conductive contact is established through defined destruction of the oxide layer in the slot base and on the slot flanks. The cable lug must be positioned between the serrated washer and the washer during assembly.

Sliding carriage Base structure in extruded section, aluminium EN AW6060. Sliding elements Maintenance free plain bearing iglidur® J. Version Eloxalcoated E6/EV1. Black thermoplastic Note With a low rate of inerita, high accelerations and short term extreme speeds up to 30 m/s are possible. DryLin® T linear glide guides are resistant to dirt and corrosion and are adjustable, maintenancefree and quiet. Application temperature max. 80 °C. As no lubricants are used they are recommended for use in food, medical, and clean room technologies. Manual clamping was developed for simple functions. Polymer under constant pressure has a tendency to creep which causes a decrease in clamping force over time (up to 70%), which means that no safetyrelevant parts should be clamped. Suitable guide rails see 21200. Drawing reference 1) manual clamping