Turkey
Manufacturer/ Producer
Almesan is a member of Selcuklu Group and established in September 2007 in Arslanbey Industrial Zone Kocaeli and start up production by February 2009 Located in an 80.000m² open and 50.000m² closed area.Almesan is the one and the first company using Hazelett Casting Technology with a tandem hot Rolling mill in Turkey. In our production process, addition to low alloy products, the deep drawable high Mg alloy products are targeted.Almesan is furnished by 40 tons melting and 30 tons tiltable holding furnace with a casting capacity of 5 - 7 tons hot rolled coil in an hour.In the existing line 19-50 mm thickness 305-600 mm width and 2-3 tons of hot coils can be castable.With the produced coils• In various thickness and diameter deep drawable circle• 12mm -111mm diameter, 25 - 23mm thickness impact extrusion slugs• 600mm width evaporator and heat shields• 0, 3-12mm thickness and 600mm width coils and sheets
Netherlands
Dutch Scrap Recycling B.V. Is the leading trader in Iron, Aluminium, copper, plastic, rubber , Paper, copper cathode scraps in the Netherlands and Continues to Be a Family Business With Four Generations Working to Innovate the Recycling Industry.
Request for a quoteNetherlands
Dutch Scrap Recycling B.V. Is the leading trader in Iron, Aluminium, copper, plastic, rubber , Paper, copper cathode scraps in the Netherlands and Continues to Be a Family Business With Four Generations Working to Innovate the Recycling Industry.
Request for a quoteTurkey
It has similar application areas with PVC. It has chemical resistance to acids and bases. It features weldability. Weldability is more difficult than PVC but more resistant weld seams are obtained. It has higher temperature resistance than polyethylene and PVC. Cost is low and economical since its density is very low. It has a high impact resistance. It can be used on section plates. Mechanical strength values are better compared to Polyethylene.
Request for a quoteTurkey
It has similar application areas with PVC. It has chemical resistance to acids and bases. It features weldability. Weldability is more difficult than PVC but more resistant weld seams are obtained. It has higher temperature resistance than polyethylene and PVC. Cost is low and economical since its density is very low. It has a high impact resistance. It can be used on section plates. Mechanical strength values are better compared to Polyethylene.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.