ALWA MOULD COAT is a vinylester resin and is used for surfaces of RTM, polyester and laminate moulds.
Germany
ALWA BARRIER COAT is a laminate resin, which is applied to protect the gelcoat for instance with glass fleece (e.g., ALWA MOULD COAT and ALWA UP GELCOAT).
Request for a quoteGermany
ALWA UP GELCOAT is an aluminium filled polyester surface resin with a temperature resistance of 110 °C. Pot life is approx. 20 – 30 min. at room temperature, when using 1 – 2 % hardener (art. no. 3150001). The top layer can be polished to high gloss.
Request for a quoteGermany
Our patented material is highly suitable to produce foam moulds and RTM pressure injection moulds. Advantages: • Large volumes of more than 2500 kg can be cast in less than 45 min. • Good castability • Hardly measurable linear shrinkage • High temperature resistance • Demoulding process after approx. 90 min. (after adding the last backfilling compound) • Chemical adhesion to polyester or vinylester gelcoat • Immediately after the first mould half has cooled down, the second mould half can be prepared • Copper pipes keep the mould surface on a nearly constant temperature • Post-curing is not necessary ALWA MOULD D backfilling compounds are the fastest system on the market. For the surface you can chose between two gelcoats: 1) ALWA MOULD COAT This is a vinylester gelcoat that is especially suitable for high-end surfaces. It can be polished to high-gloss. 2) ALWA EPF 10 This is an epoxy gelcoat that is easy-to-use and is recommended for parts, where high-gloss surfaces are not needed
Request for a quote