BEULCO GMBH & CO. KG
BEULCO Clean is a disinfectant based on natural ingredients. It is non-toxic and degrades 100%. It is produced by a special process (ECA process) without the use of additives. This enables the wide range of applications of the active ingredient. BEULCO Clean is even used in other areas for the disinfection of drinking water systems and for drinking water disinfection. The solution differs from conventional active ingredients of this type because only a very short reaction time is required and the agent is quickly broken down again.
Ready-to-use spray solution for surface disinfection. Bactericidal, fungicidal, effective against enveloped viruses such as influenza or corona. Clean surface thoroughly before disinfection. Wet surfaces completely.
Allow to act for 5 minutes; in case of contamination with fungi, allow to act for 15 minutes. Wipe with a clean cloth. Repeat if necessary.
To avoid the backflow of materials up to category 4 into the drinking water installation, the backflow
preventer BA (acc. to DIN EN 1717 a “backflow preventer with a controllable middle pression
area”) is used as an approved safety device.
The mobile BEULCO disinfection box was developed in accordance with the applicable national standards and guidelines and is primarily designed for the hygienic and safe disinfection of drinking water pipes in public buildings. The disinfection box is particularly suitable for the disinfection of drinking water systems in new buildings and pipeline renovation.
Professional disinfection of:
— Drinking water installations (buildings, fairgrounds, camping sites, sports facilities, allotment gardens, marinas etc.)
— Drinking water hoses
— Sub-distribution of drinking water e.g. at fairs and markets
— Sales stands e.g. at fairs and markets
HESMER ANTRIEBSTECHNIK GMBH & CO. KG
JÄGER & FRESE GMBH
EMILE MAURIN - ELEMENTS STANDARD MECANIQUES
IKO NIPPON THOMPSON EUROPE B.V.
IKO Precision Elevating Table TZ is an elevating table that performs precision positioning in the up and down directions by using the wedge mechanism.The wedge mechanism applied IKO Linear Way has achieved both high accuracy and high rigidity with a compact size.
The IKO Alignment Module AM is a positioning module developed for alignment stages by combining high rigidity Crossed Roller Bearings and Linear Way E with Precision Positioning Table TU. Alignment stages can be configured without adjusting the height of each alignment module, since the height tolerance is managed with high accuracy of ±10 μm.
Alignment Table AT is a rotary positioning mechanism capable of precise angle correction, in which a high rigidity steel table and bed are used and IKO Crossed Roller Bearings are incorporated in the bearings supporting the table. Alignment Table AT uses the ball screw drive to convert linear motion into circular motion in a fixed angle range and positions the table in the rotational direction. An IKO Linear Way L is used for the linear motion rolling guide of the ball screw drive mechanism, combined with a precision ball screw to achieve high precision positioning. Placing Alignment Table AT on the slide table of the IKO Precision Positioning Table enables the configuration of a low height XYθ multiaxis positioning mechanism. This enables the table to be used as an alignment table for precision measuring equipment, inspection equipment and assemblers.
IKO Super Precision Positioning Table TX is a positioning table with extremely high accuracy which is created based on the high precision, high rigidity and well proven IKOPrecision Positioning Table LH by using cylindrical rollers for rolling elements and incorporating IKOLinear Roller Way Super X, which has bestinclass running performance as a linear motion rolling guide, with fullyclosed loop control. Optimal for highly accurate positioning where the existing rolling guides could not be used.