Inline homogenizer YSTRAL Z-Inline Disperser

Flexibility in chemical, food, cosmetic and pharmaceutical production. With only one machine, different products and product quantities can be produced with the most suitable tool. The tool shaft can be easily disconnected from the drive, e.g. for cleaning, while continuing to work with a second shaft. The tool shaft has a shaft bearing separate to the motor, which is driven via a plug connection. The possibility of adding a mobile lifting stand offers additional flexibility. Batch sizes from 5 to 1,000 l are covered by the X50, X100 and X200 series. The X100/X50 adapter enables an X100 to be used to produce batches ranging from 5 to 1,000 l. By simply exchanging the shafts, it is possible to conduct jet mixing, mixing dispersion, dispersion, powder aspiration and wetting. Maximum flexibility creates investment security - short set-up times and easy handling.

The combination of different process steps in one machine provides you with great rationalisation potential: Production times are minimised, sub-processes are completely eliminated, production costs are reduced.The YSTRAL Conti-TDS is based on the same principle as the YSTRAL Inline Disperser. A special rotor-stator system generates a large negative pressure and absorbs powder, without dust formation and loss-free, directly into the liquid. The inducted powder is dispersed immediately and under high shear. Clean manufacturing process thanks to a dust and loss-free powder feed, even with powders that are difficult to wet, sticky or dusty Aspirating and dispersing of powders directly from silo (via buffer hopper), big bag, hopper, sack, barrel etc. Optimized result a better digestion, a higher effectiveness of the raw materials and a higher product quality.

The YSTRAL jet stream mixer fulfils all requirements for a complete and homogeneous mixing of the contents of a vessel. Effective micro- and macro-mixing of the entire contents of the vessel without the introduction of air. Complete mass transfer across all vessel levels due to vertical mixing. Up to 90% of the energy used is converted into vertical flow - no rotating vessel contents. Even heavy sediments are suspended by directed streams. Rotating parts are protected against unintentional intervention. With open tanks no tank fixing is necessary. A fast rotating rotor surrounded by a stator generates a downward directed guide jet which directs the liquid flow directly to the bottom of the container. At the bottom of the container, the stream splits and creates an upward flow on the outer wall. At the surface, the liquid flow is redirected towards the bottom of the tank.

Intensive vertical mixing of the container ingredients in the micro and macro range. An additional downstream shear ring dispersion is not necessary. Due to optimal dispersion performance, high efficiency and easy handling of the mixing tools used, the Dispermix meets the high requirements of demanding production processes for the introduction of liquids or powders into liquid. Agglomerates are crushed and thus better wetting of the powder with the liquid. Different slot widths allow the adaptation to the corresponding application. The Dispermix head generates two differently directed liquid streams. A vertical partial flow is directed straight to the vessel bottom, where it is divided and circulates the entire vessel contents. A second partial stream is deflected horizontally in the Dispermix head and guided through the dispersion zone. Solid particles and/or droplets are reliably comminuted and homogeneously distributed.