POLYETHYLENE (PE)

It has similar application areas with PVC. It has chemical resistance to acids and bases. It features weldability. Weldability is more difficult than PVC but more resistant weld seams are obtained. It has higher temperature resistance than polyethylene and PVC. Cost is low and economical since its density is very low. It has a high impact resistance. It can be used on section plates. Mechanical strength values are better compared to Polyethylene.

Textile industry, Confection, Automotive, Heavy industry (Iron-Steel industry), Agricultural sector and Machinery manufacturing, PLATE DIMENSIONS: 850 x 1170, 1000 x 2000 PLATE THICKNESSES: 0,50, 100 mm FENOL FIBER BAR : Ø 8 - 200 mm are available. Their lengths is 1000 mm. PERTINAKS PLATES AREAS OF USE : Electrical insulation, Printing machines, Textile industry, Automotive industry. PLATE DIMENSIONS: 850 x 1170, 1000 x 2000 PLATE THICKNESSES: 0,50, 50 mm VULCANIZED FIBER PLASTICS AREAS OF USE : Textile industry, Automotive, Electronics and other fields. FIELDS OF APPLICATION : Textile (in cotton yarn collection bins in programmed machines) Water armatures, Gasket making, Weak current insulation, Manufacture of agricultural sector machines.

It is a material widely used in machinery industry. It is a material with relatively hardness, rigidness, slippery and good mechanical strength values. There are various uses for its gear applications, including wheel construction. However, it is not as hard and abrasion resistant as Kestamid, not as slippery as Pom C. Its chemical strength is moderate, and it is resistant to some acids and bases. The polyamide 6 has the ability to collect water on its own. These features have pros and cons. Pros is that it increases the strength of the part against vibration and sudden impacts. This allzws the dynamic stresses that would otherwise occur during part use to be removed within itself. Cons is that it is difficult to achieve measurement stability in the material. In other words, the material is affected even by the moisture in the air and gets changes in the measurement. The tolerances must be observed before finishing the final processes of the part.

BUSHING / SHEET PLATE / AVRUPA ROLLED BRONZE / ALUMINUM BRONZE / PHOSPHOR BRONZE BAR / PHOSPHOR BRONZE PLATE - STRIP. Note : Bronze casting materials without any standard are manufactured at desired analysis and at every size.