VIRA ISI

The ViraVent air separator units are installed to efficiently remove air and microbubbles from the system. In heating systems, an air separator should be installed in the flow loop where the system experiences the highest temperature (next to the heat source) and lowest pressure.

In heating and air conditioning control systems, the circulation of water containing impurities may result in rapid wear and damage to components such as pumps and control valves. It also causes blockages in the heat exchangers, heating elements, and pipes, resulting in a lower thermal efficiency within the system. The dirt separator separates off these dirt particles, collecting them in a large collection chamber, from which they can be removed even while the system is in operation. This device is capable of efficiently removing even the smallest particles, with extremely limited head loss.

ViraPlus combined dirt and air separators can be used instead of individual deaerators and dirt separators. These combined units are very efficient and extremely cost-effective, becoming the preferred standard option throughout the industry. In heating systems, the units should be installed in the flow loop, situated immediately after the boiler and prior to the pump. In a chilled water system, the unit must be located in the return loop close to the chiller. Removes circulating air and micro bubbles effectively Very small particles, from 5 μm (= 0.005 mm) are separated and removed Dirt can be discharged while the system is in operation Constant low-pressure drop Exceptional guarantee

The hydronic separator is a device that makes the primary and secondary circuits connected to it independently and can be used on hot or chilled water systems. The separator is supplied with an air-vent and check valve assembly to permit the automatic discharge of the air in the circuits, and a drain valve for removing any İmpurities deposited in the bottom of the unit. Three functions in a single component Just four connections instead of eight Optimum hydraulic balance between primary and secondary pumps Viratube guarantees minimal fluid mixing and thus the best temperature differential Real, active deaeration and dirt separation Even the tiniest air bubbles and dirt particles are separated and removed Constant low-pressure drop Compact design and limited built-in height, thanks to the Viratube Exceptional guarantee

Viratop Automatic Air Vents automatically purges air, micro bubbles, and other gases from the system into the atmosphere quickly and reliably. Air can be collected at high points or specifically designated collection points. There is a float-controlled vent valve in the air collection chamber of the Viratop. If the float loses buoyancy due to the air that has accumulated in the collection chamber, it sinks and the vent valve opens. Automatically air is purged. The float has enough space to move freely even if there are dirt deposits in the air collection chamber. This ensures to protect the valve mechanism from dirt.

The ViraClean is a high-efficiency in-line dirt trap, suitable for use on heating and chilled systems. Corrosion is a process that is difficult, if not impossible, to stop once it has begun. Corroded metal becomes dislodged and becomes water-borne debris. This debris, along with other contaminants in the system, clogs heat exchanger channels, fouls filters, and causes excessive wear in circulating pumps. Effective removal of debris is essential for increasing the operational life of the system as a whole.

The ViraClean is a high-efficiency in-line dirt trap, suitable for use on heating and chilled systems. Corrosion is a process that is difficult, if not impossible, to stop once it has begun. Corroded metal becomes dislodged and becomes water-borne debris. This debris, along with other contaminants in the system, clogs heat exchanger channels, fouls filters, and causes excessive wear in circulating pumps. Effective removal of debris is essential for increasing the operational life of the system as a whole.

Dosing pots are required in order to feed liquid chemicals such as corrosion inhibitors into closed systems. The dosing pots consist of a mild steel vessel with an inlet (return) and outlet (flow) valves, a drain valve, and a filling valve. A steel tundish, air release valve, wall mounting brackets, and a non-return valve. Dosing pots can also be supplied without the valves, and air release valve if requested.

Magnetic Deaerator and Dirt Separator are used with a single device to dissolve microbubbles, dirt, and air in high performance in heating and cooling installations. Micro smart filter design is the most important element of the system design. Optimum air and microbubble separation and very low flow resistance are available. It also has a high degree of dirt handling. With its magnetic Separator feature, ViraPlus separates the moving metal particles in the installation more effectively and ensures faster cleaning of the installation. It also extends the life of your pump and other connecting equipment by minimizing the damage caused by metal parts to high-efficiency pumps that provide low energy consumption.