Air pressure switch - Import export

Pneumatically actuated magnetic gripper type PNEUMAG are pneumatic switchable bi-stable magnetic systems. Air pressure is only needed for switching. The magnet system is permanent and thus keeps safe even with pressure drop. PNEUMAG magnetic grippers enable thin, perforated or textured sheet metal parts (from 0,5mm) take and safe to transport what they recommended specifically for use in automatic and semi-automatic feeding systems as well as slings for robot grippers. PNEUMAG is the alternative to vacuum conveying systems. They were tested on a metal sheet St37 with smooth and clean surface. Note that depending on the application a safety factor of 2 or 3 has to be included.

Wide supply voltage range 7 to 40 V Wide compensated range (0 to 70°C) Total accuracy down to 1% over 0 to 70°C, all effects included (maximum) Standard 0.5 to 4.5 V analog output Digital I2C output up to 15 bits (pressure + temperature) Overcurrent and overvoltage protection Overload and short circuit protection Integrated EMC protection Standard M8 output connector Gage configuration 20 mBar – 7 Bar

Wide supply voltage range 7 to 40 V Wide compensated range (0 to 70°C) Total accuracy down to 1% over 0 to 70°C, all effects included (maximum) Standard 0.5 to 4.5 V analog output Digital I2C output up to 15 bits (pressure + temperature) Overcurrent and overvoltage protection Overload and short circuit protection Standard M8 output connector Gage configuration 20 mBar – 7 Bar, or vacuum

The function of a Pressure Switch is to provide a path for an electrical circuit that is triggered at a certain pressure. Example uses are: •Oil pressure warning light in an automobile •Pump controller (turn well pump on and off) •Air compressor control •Industrial process signaling A pressure switch must have a process connection (usually threaded for a pipe or tube) and an electrical contact that is connected to wires or terminals. They may sense rising or falling pressure and most are adjustable, so the contact will engage (or turn on the electrical circuit) at a desired pressure setting. They can be pneumatic (air and gases) or hydraulic (water, oil or fluids) or even strictly mechanical. The internals can be a diaphragm capsule, a small chamber backed by a spring or a bourdon tube. The contact is usually copper points but can also be a mercury (in glass) tip switch. Unlike Pressure Transducers which give an analog electrical signal proportional to the amount of pressure, these

Low pressure screw air compressor series is a new compressor produced according to the national policy of energy saving,emission reduction and environment protection.It changes the traditional compressor with relatively high pressure.It transfers the compressed air after pressure reduction to the air consumer,which waste large amounts of energy. The low pressure screw air compressor can be distributed according to the air pressure of the user,to satisfy the process flow with minimum energy.The manufacturing cost of your product can be largely improved.For example,if your process system only needs 3 bar pressure and the used compressor can provide 7 bar, then it can be reduced to 3 bar, It may take two times power to satisfy you process system, you can choose our low pressure screw compressor only to consume half of the power,and the air pressure in the process system can still be ensured, thus realizing energy saving and emission reduction.