Plastic nuts - Import export

Steel C35Pb. Gunmetal Rg7. Plastic PA6.6 with MoS2). ISO trapezoidal thread based on DIN 103. Steel nuts for adjustments during manual operation and as fastening nuts. Not advised for use with motorised drives due to the steelsteel material combination. Gunmetal nuts for motion drives with low and medium speed. By insufficient lubrication, gunmetal trapezoidal thread nuts on steel spindles have good dryrunning properties. Plastic nuts for lownoise motion drives. Good dryrunning properties. Tolerance class 7H.

Bearing block and carriage aluminium alloy. Guide column and threaded spindle stainless steel. Plain bearing for guide columns and spindle nut highquality special plastic. Claw coupling aluminium with polyurethane coupling spider. Version Aluminium alloy anodised. Stainless steel hardened and ground. Threaded spindle with ball bearing. Note for ordering The unit is supplied with the position of cable outlet or control unit as shown in the drawing. Note Positioning stages for motorised adjustment and positioning tasks. The plain bearings and spindle nuts are suitable for dry running, however lubrication with a grease for plastic plain bearings is recommended. The suitable programming software and interface cable for the stepper motor with positioning control are available as accessories (2500015).

Chain clamps are used mainly in machine and plant construction. Chain clamps enable cylindrical, complicated and large to very large workpieces to be clamped securely and effectively in the quickest and easiest way. Suitable for cylindrical workpieces, valve bodies, pistons etc. The workpiece surface can be protected by attaching the plastic elements. Application: The knurled nut on the clamping bracket can be used to preset the chain length and the clamping force. The required torque is set on the clamping hook. Accessory: Steel roller chains for chain clamp sets 04211-03. Steel turnbuckles for chain clamp sets 04211-06. Steel prisms for chain clamp sets 04211-09. Nuts for T-slots DIN 508 enhanced, 07060. Cap screws DIN EN ISO 4762, 07160. Note: The opening angle of the chain should not exceed 30°. Do not exceed max. permitted tightening torques. Supplied with Chain clamp set 04211-15: Clamping hook. Clamping bracket.

Tensioner Vesconite® plastic. Screw and nut steel. Version Screw ISO 4017, grade 8.8, electro zincplated. Nut ISO 4035, grade 8, electro zincplated. Note For tensioning roller chains. The chain tensioner set can be combined with all tensioning elements to form a readytoinstall chain clamp. The symmetrical design enables use on both sides. Large radii ensure very quiet running. The highquality plastic does not require any lubrication. The maximum chain speed should not exceed 1.5 m/s in continuous use.

Housing fibreglass reinforced thermoplastic polyamide. Sight glass thermoplastic polyamide. O-ring and flat seal NBR. Reflector PVC. Float plastic. Screw and nut, steel. Version: Housing black. Sight glass crystal clear, high mechanical stability, non-ageing. Reflector white. Float red, with magnetic element. Screw and nut electro zinc-plated. Note: The oil level gauge not only enables the oil level to be viewed but also recorded using a REED switch. In addition, the oil level gauges can also emit an electric signal if the temperature of the liquid inside the container reaches the threshold of 70 °C. As soon as the float element approaches the selected minimum value after the circuit has been closed, the system emits an electric signal. The sensor is located on the housing and its height can be adjusted in line with the control requirements for the oil level. The minimum level is ca. 35 mm from the centre of the lower fastening screw.