Horizontal cutters - Import export

HORIZONTAL DOUBLE CUTTERS BD 122 - BD 220 Universal cutters for cutting paper, corrugated cardboard, reinforced papers and polythene, polyethylene foil, polyethylene bubble, polyethylene foam. This series is very useful because you can use at the same time two different materials. The use of the cutter is extremely simple: it is necessary to carry the material to the desired length and manually operate the blade holding carriage, the cut is clean and precise in both directions. All the cutters are mounted on a frame complete with coil holder and rubber feet, on request may have the wheels with brake. For reasons of space the product is shipped disassembled. The cutter can be equipped with: RHOMBOIDAL BLADES: suitable for cutting plastic film, polyethylene foil, bubble wrap or foam. CIRCULAR BLADES: suitable for cutting paper, corrugated paper and reinforced.

Horizontal End-Suction Pumps are centrifugal inline pumps with a compact design where the impeller is mounted onto the extended motor shaft. These pumps are not self-priming and must be gravity fed. All pumps are equipped with double mechanical seal. This pump series is designed for horizontal installations next to a tank and are capable of cutting aluminium chips and similar materials and pumping of these materials along with the coolant fluid. An agitator located at the pump suction helps to break up and separate any large bundles of chips or birds nests which reach the pump suction. The specially made cutting unit (>60 HRC) is cuting chips and the above located semi-open impeller allows with its large clearances to pump the particles along with the coolant fluid from the machine back to the filter. The SBC pumps are capable of handling chip to coolant ratios of up to 1.5% by weight. Volumetric delivery: up to 1400 l/min Delivery head: up to 34 m

Pressure Boosting Pumps series TH and FH use closed impellers in order to minimize power consumption and to optimize hydraulic pump efficiencies. In addition, the TH series offers high pressures at short immersion depths. Inline pumps of the series FH can be used as boosting pumps if provided with positive inlet pressure. This inlet pressure can be provided by the central coolant supply or a feed pump. In such a setup, pumps of the series FH can raise the incoming pressure by up to 26 bar. A frequency converter can be supplied for special applications or for matching the pump characteristic to a specific duty point. See page "Control/Regulation" in the Technical Information Volumetric delivery: up to 640 l/min Delivery head: up to 520 m Horizontal cutter pumps

Semi-automatic, compact cutting machine designed to horizontally split cheese. Gives the same results as when hard cheeses are cut manually, reducing waste to a minimum. Main technical features: Horizontal circular cutter, for precise incision of the rind with no waste Safety sensors to detect the presence and correct centring of the wheel Made in compliance with EC standards

Semi-automatic cheese cutter model for horizontally cutting cheese with steel wire. First an incision is made in the rind after which the cheese is electrically cut horizontally by a stainless steel wire. The whole cutting procedures is waste-free. Technical equipment: motorized circular cutter for precise incision of the rind with no waste clutch controlled wire unwinding and electric cutting also available with manual wire winding wheel presence safety sensors Made in compliance with EC standards Optional accessories: Kit for manually dividing the wheel into 3 – 4 discs