Changeover switches - Import export

Body Raw Material; PA 6,6 PC Raw Material; PC Body Colors; Black, White, Gray Key Colors; Black, White, Gray, Red, Yellow, Green Terminal Connection; Quick Connection 6,3 mm x 0,80 mm Electrical Values; 10A T85, 10A(2) T125, 16A(4) T125 Working Function; Changeover Number of Cycles; 10.000

In sizes 1/8 - 1/4 Control ranges from 0.2 to 300 bar

The angle transducers have a magnetic scanning according to the HALL principle. Due to the robust design, critical and interference-free applications in harsh environments can be realized. They have a robust housing (wall thickness > 5 mm) made of aluminium or stainless steel, shaft and ball bearing made of stainless steel, shaft with flattening, rotor with shaft and permanent magnet mounted in prechamber, sensor circuit consisting of ASIC with Hall elements and interface electronics housed in closed main chamber. Two models are available: For low and high temperature applications. The model for low-temperature use is equipped with a special grease for bearings and shaft seal. Seals and shaft seal are made of PTFE. Cable gland with clamping jaw pressure screw and silicone seal. The model for high temperature use is without shaft seal. Under the rear cover there is a signal changeover switch (CW/CCW). On the side there is a preset button (4 mA) placed under a screw plug.

TYP C 034/S Cutting, stamping and bending device for axial components Description To facilitate the placement of short axial leaded components that must be cut before insertion into the circuit board to the appropriate length and bent to the required height. In the device C 034/S can be set via adjustment screws both cutting length and height and the components are then processed. The setting is displayed on the relevant scale of the device. The component is manually inserted between the tools. Those are actuated by a pneumatic foot switch. The changeover for different cutting and grid dimensions happens in less than a minute. Components

TYP C 034/Mil Cutting, stamping and bending device for axial components Description To facilitate the placement of short axial leaded components that must be cut before insertion into the circuit board to the appropriate length and bent to the required height. In the device can be adjusted via adjustment screws C 034/Mil both cutting length and height and the components are then processed. The setting is displayed on the relevant scale of the device. The component is manually inserted between the tools. Those are actuated by a pneumatic foot switch. The changeover for different cutting and grid dimensions happens in less than a minute. Components