Wireless temperature sensors - Import export

The device can perform water pressure measurements in the water supply network and temperature measurement in 2 places - on the sensor itself and in the device housing. The sensor is produced in two versions - IP54 (possible replacement of the battery on the user's side on the object) or IP68 (battery replacement only in the manufacturer's service) The sensor measures at intervals of 1 min to detect sudden pressure increases. It is possible to set an alarm threshold, the exceeding of which triggers the immediate sending of data frames. In normal operation mode, reading reporting takes place with an interval of 15 minutes every 6 hours from the last 24 hours.

The measuring probe lance is in the form of a length of 2000 mm and includes the three temperature sensors: - on the tip of the lance - at a distance of 750 mm from the tip and - at a distance of 500 mm from the end of the lance The lance tip has a rounded head, so when pushing into the pile it does not poke through encountered "in the way" compost components. The probe in wireless version is powered by a battery. Measurements and data are transmitted, depending on the version of the device, by wire or wireless.

Wireless fire detector with temperature sensor that monitors security in the room twenty four hours a day and immediately notifies of smoke and sharp jumps in temperature.

We are offering very wide spectrum of radio connected sensors. In addition to Humidity and Temperature, we also offer light, gas (Ozon, Oxygen, CO2 and more), air quality, vibration, level, noise, air pressure and more. All sensors are connected to the gateway and can be monitored through our online monitoring system.

Predictive maintenance needs measured data to the greatest possible precision. On components with moving or rotating parts, the relevant measuring points (e. g. temperature of an electric motor’s rotor or planetary gearbox bearing) sometimes cannot be accessed with wired sensors. Accordingly, the data needed for condition monitoring can be obtained only with complex calculations and estimates. However, precise and reliable measured data are obtained only when a sensor is placed directly on the moving part. For requirements of this kind we have developed NORIFID, a simple, cost effective measuring system that is based on established technologies, supplies wirelessly power by induction to a sensor on a moving part, and transmits the measured data via RFID to a fixed receiver.

The fuel temperature sensor is one factor that tells the ECU how to adjust the amount of fuel injected. When the fuel is warm, it's less dense and burns more readily so the ecu injects more fuel to get the same mass of fuel and retards the timing. When the fuel is cold, it's more dense so the ecu injects less fuel and advances the timing. Hot fuel has the same effect as higher cetane fuel at a lower temperature because it burns more readily. Timing and injection quantity is also based on many other factors, fuel temperature is just one of them.